Dulytek DHP7 Руководство по эксплуатации - Страница 11
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Электроинструмент Dulytek DHP7. Dulytek DHP7 12 страниц. Heat press
INSTRUCTION MANUAL: DHP7
OPERATING INSTRUCTIONS
SETTING
CONTROL
PANEL
(continued)
PRESSING
TURNING OFF
PRESS
Dulytek Equipment
www.dulytek.com
9. Now, press SET button once more to record the settings (Figure 13).
The display screen shows the current temperature of the corresponding
platen on the "PV" line and your desired temperature on the "SV" line
(Figure 14).
Figure 13
1. Wait until the platens heat up to the desired temperature. Tip: The
temperatures shown on both "PV" and "SV" lines should be the same.
2. Place the material you wish to press in the center of the bottom platen
3. Pump the handle
on your work material. Release the handle when the desired pressure is
reached.
4. Press the timer ON / OFF button
the remaining time is shown on the "SV" line of the control panel .
5. Wait until the countdown ends and the display on the control panel
shows "0" on the "SV" line. Tip: the press starts beeping as soon as the
time is up.
6. Press the ON / OFF button again to turn off the timer.
7. Open the release valve by turning the knob
press lowers down the bottom platen
8. Remove the pressed material using heat resistant gloves or tools and
exercising extreme caution.
1. Remove the pump handle
2. Turn the machine off by flipping ON / OFF switch when done pressing.
3. Unplug and then disconnect the AC power cord from the press.
4. Wait until the press cools down completely to store it.
Email: [email protected]
(continued)
Figure 14
F
moving up the bottom platen
D
. The countdown starts immediately;
D
C
F
from the pump handle socket
C
and applying load
counterclockwise. The
H
.
I
© 2018 Dulytek
All rights reserved
PAGE 10
..
C
E
G
.