Dulytek DHP7 Інструкція з експлуатації - Сторінка 11

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Електроінструмент Dulytek DHP7. Dulytek DHP7 12 сторінок. Heat press

INSTRUCTION MANUAL: DHP7

OPERATING INSTRUCTIONS

SETTING

CONTROL

PANEL

(continued)

PRESSING

TURNING OFF

PRESS

Dulytek Equipment

www.dulytek.com

9. Now, press SET button once more to record the settings (Figure 13).

The display screen shows the current temperature of the corresponding

platen on the "PV" line and your desired temperature on the "SV" line

(Figure 14).

Figure 13

1. Wait until the platens heat up to the desired temperature. Tip: The

temperatures shown on both "PV" and "SV" lines should be the same.

2. Place the material you wish to press in the center of the bottom platen

3. Pump the handle

on your work material. Release the handle when the desired pressure is

reached.

4. Press the timer ON / OFF button

the remaining time is shown on the "SV" line of the control panel .

5. Wait until the countdown ends and the display on the control panel

shows "0" on the "SV" line. Tip: the press starts beeping as soon as the

time is up.

6. Press the ON / OFF button again to turn off the timer.

7. Open the release valve by turning the knob

press lowers down the bottom platen

8. Remove the pressed material using heat resistant gloves or tools and

exercising extreme caution.

1. Remove the pump handle

2. Turn the machine off by flipping ON / OFF switch when done pressing.

3. Unplug and then disconnect the AC power cord from the press.

4. Wait until the press cools down completely to store it.

(continued)

Figure 14

moving up the bottom platen

. The countdown starts immediately;

from the pump handle socket

and applying load

counterclockwise. The

PAGE 10