AOM 3A MIX Руководство по эксплуатации и техническому обслуживанию - Страница 12

Просмотреть онлайн или скачать pdf Руководство по эксплуатации и техническому обслуживанию для Краскопульт AOM 3A MIX. AOM 3A MIX 17 страниц.

USE AND MAINTENANCE MANUAL

4.1 PRESSURE DISCHARGE PROCEDURES

When stopping the system to carry out operations on the unit, or when stopping it at the end

of the working day, the high pressure inside the unit must be completely discharged. When

the main air inlet is shut off, the air is automatically discharged from the pump motor.

WARNING

The product in the flexible tube is still under pressure.

PROCEED AS FOLLOWS:

Lock spray gun lever with the safety trigger lock (4) (see pag. 7).

Shut off the air supply to the equipment.

Unlock the lever safety bolt.

Take a metal bucket, make sure it is firmly fixed on the ground and keep the spray gun

pressed tightly against the walls of the bucket. Pull lever to discharge the product.

The routine maintenance of the K1 3A MIX gun is simple and does not require special

operations because its components do not need to be lubricated. Clean the gun daily or at

the end of each working session so that product residues will not dry out on its walls, thus

guaranteeing long term efficiency.

CLEANING:

Unscrew the cap clamping ring, remove the self-cleaner and dismantle the nozzle. Place

everything in the thinner. Carefully clean the nozzle, dip it in thinner to dissolve residues inside

of it. Blow commpressed air throught it from the front to eliminate all traces of material. The

nozzle must be daily mounted back on with its gasket. Clean the head of the gun and the tip of

the nozzle with the provided brush; at least once a week dismantle and clean the product

needle too. Reassemble the gun, lubricate the threads with a thin layer of oil, and close tightly.

DO NOT USE POINTED METAL OBJECTS TO CLEAN CLOGGED PASSAGE HOLES.

THESE OPERATIONS WOULD DAMAGE THEM, REDUCING THE SPRAYING

QUALITY.

Clean the body of the pump with a cloth soaked in thinner. In case industrial washers are used

to clean the gun, close the fan adjustment and the needle adjustment tightly by turning them

clockwise in order to avoid thinner infiltrations which in the long run may damage gaskets.

Once in a while, lubricate the threaded parts such as the cap clamping ring, the needle adjustment

and the air valve cap (including the dip rod) with a thin layer of synthetic oil, in order to avoid

seizing up caused by the effect of thinners on the gun components.

THE LUBRICANTS USED MUST NOT CONTAIN SILICONE.

WARNING

IF THE NEED ARISES CALL THE ASTURO ORIGINALI MAVES Spa CUSTOMER CARE

SERVICE.

Page 12 of 14