Danfoss TP5000 RF Si Руководство по установке - Страница 6

Просмотреть онлайн или скачать pdf Руководство по установке для Термостат Danfoss TP5000 RF Si. Danfoss TP5000 RF Si 14 страниц. 5/2 day programmable electronic room thermostat
Также для Danfoss TP5000 RF Si: Руководство по установке и инструкции по эксплуатации (14 страниц), Инструкции пользователя (2 страниц)

Commissioning (RF models only)

If the thermostat and the receiver have been supplied together in

a combined pack, the units have been paired in the factory and no

commissioning is required (RX1 only).

To tune the RX receiver to the frequency of the thermostat signal, follow

steps 1-5 below.

Step 1 TP5000-RF

Reset the unit by pressing and

holding -, +, V and Λ together

until display goes blank.

Step 2 Press and hold V and +

buttons for 3 seconds (TP5000

now transmits unique signal continuously for 5 minutes).

Step 3 RX1

Press and hold buttons PROG

and CH1 for 3 seconds until green

light ﬂ ashes once.

Step 4 RX2 (if applicable)

Stat 1 - perform steps 1-3.

Stat 2 - wait 5 mins, perform steps 1-2 and then press

PROG and CH2 on RX2.

RX3 (if applicable)

Stat 1 - perform steps 1-3.

Stat 2 - wait 5 mins, perform steps 1-2 and then press

PROG and CH2 on RX3.

Stat 3 - wait 5 mins, perform steps 1-2 and then press

PROG and CH3 on RX3.

Step 5 TP5000-RF

Press V or Λ to select temperature - the unit will revert back

to operating mode.