Danfoss TP5000 RF Si 설치 지침 매뉴얼 - 페이지 6
{카테고리_이름} Danfoss TP5000 RF Si에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss TP5000 RF Si 14 페이지. 5/2 day programmable electronic room thermostat
Danfoss TP5000 RF Si에 대해서도 마찬가지입니다: 설치 및 사용자 지침 매뉴얼 (14 페이지), 사용자 지침 (2 페이지)
페이지 인쇄
- 1. Installation Instructions
- 2. Product Specification
- 3. Installation
- 4. Commissioning (RF Models Only)
- 5. Your Programmable Room Thermostat
- 6. Preset Programmes
- 7. User Instructions
- 8. Before You Start
- 9. Setting the Clock & Day
- 10. Running Your Programme
- 11. Before You Change the Preset Programmes
- 12. Changing the Preset Programmes
- 13. User Overrides
- 14. Frost Protection
- 15. Battery Replacement
Commissioning (RF models only)
GB
If the thermostat and the receiver have been supplied together in
a combined pack, the units have been paired in the factory and no
commissioning is required (RX1 only).
To tune the RX receiver to the frequency of the thermostat signal, follow
steps 1-5 below.
Step 1 TP5000-RF
Reset the unit by pressing and
holding -, +, V and Λ together
until display goes blank.
Step 2 Press and hold V and +
buttons for 3 seconds (TP5000
now transmits unique signal continuously for 5 minutes).
Step 3 RX1
Press and hold buttons PROG
and CH1 for 3 seconds until green
light fl ashes once.
Step 4 RX2 (if applicable)
Stat 1 - perform steps 1-3.
Stat 2 - wait 5 mins, perform steps 1-2 and then press
PROG and CH2 on RX2.
RX3 (if applicable)
Stat 1 - perform steps 1-3.
Stat 2 - wait 5 mins, perform steps 1-2 and then press
PROG and CH2 on RX3.
Stat 3 - wait 5 mins, perform steps 1-2 and then press
PROG and CH3 on RX3.
Step 5 TP5000-RF
Press V or Λ to select temperature - the unit will revert back
to operating mode.
6