DuPure EcoPur S-Series Руководство пользователя - Страница 5
Просмотреть онлайн или скачать pdf Руководство пользователя для Системы фильтрации воды DuPure EcoPur S-Series. DuPure EcoPur S-Series 10 страниц. Whole-home system
Печатать страницу• Be sure the floor under the EcoPur S-Series system is clean and level
• The EcoPur S-Series system uses 24 volt-60z electrical power. Always use the
transformer supplied
- Plug transformer into an indoor 120 volt, grounded outlet
- Properly ground system to conform with all codes and ordinances
• Install EcoPur S-Series system in a protected area. Be sure electrical outlet
and transformer do not come in contact with water.
- Do not attempt to treat water over 110°F with the DuPure system.
- Always connect the system to the main water supply pipe before water
heater
- Do not expose DuPure system to freezing temperatures. Water freezing in
the system causes equipment damage
• Minimize inlet water pressure is 20 psi. Maximum inlet water pressure is 125 psi.
Use pressure reducing valve if necessary
CAUTION:
• Do not use with water that is unsafe or of unknown quality
• Test water periodically to verify that the system is performing satisfactorily
• Discard small parts remaining after the installation
INSTALLATION
1. Turn off gas or electric supply
2. Turn off the water supply to pipes to be cut and drain the house water pipes
3. Open both hot and cold faucets
4. Move the EcoPur S-Series assembly into installation position (be sure the instal-
lation surface is level and smooth)
5. Plumb IN and OUT connections to and from softener
- Be sure the incoming hard water supply is directed to the INLET port of
the valve
- The valve body of the control is marked with arrows indicating the proper
flow direction
- Connections are illustrated below:
5