aevit 2.0 Руководство по установке - Страница 10
Просмотреть онлайн или скачать pdf Руководство по установке для Крепление для телевизора aevit 2.0. aevit 2.0 17 страниц. Mounting brackets
prIMArY INpUT
2.5 OThEr MOUNTINg OpTIONS
rEVErSINg AdjUSTMENT kNOB 2
The Adjustment Section of the mounting systems
comes pre-assembled with Adjustment Knob
2 on the bottom of the Input Device Articulat-
ing Swivel Bracket as shown in Figure 16. In this
position, the knob will not interfere with the
input device. however, if the client wishes to have
Adjustment Knob 2 on top of the bracket (Figure
17), the following steps should be followed for
reversing it.
sTEP 1
Unscrew Adjustment Knob 2 from the 4" hex head bolt
shown in Figure 18. Remember to keep track of the hard-
ware and the order of the flat washers when disassembling
the Input Device Articulating Swivel Bracket.
sTEP 2
Insert the 4" hex head bolt into the bottom of the Input
Device Articulating Swivel Bracket and attach the remain-
ing hardware to the bracket in the following order:
-3/8" fender washer
-3/8" flat washer
-3/8" bearing
-3/8" flat washer
-Adjustment Knob 2
See Figure 19 for the full assembly.
sTEP 3
Once Adjustment Knob 2 is reversed, repeat step 4 from
the Generic Adjustment Section to fit the client. Once the
client is fitted, tighten all adjustments such that neither
the input devices nor the mounting systems move under
normal operating conditions.
FAILURE TO TIGhTEN ALL ADjUSTMENT KNOBS COMPLETELy COULD CAUSE AN
WARNING:
ACCIDENT RESULTING IN SERIOUS INjURy AND / OR DEATh.
(BrkT-AEVIT-FLr & BrkT-AEVIT dOOr
FIGuRE 16
3/8"x4" GRADE 8
BOLT
INPuT DEvIcE
SwIvEL BRACkET
3/8" FENDER WAshER
3/8" FlAT WAshER
3/8" ROllER bEARING
3/8" FlAT WAshER
FIGuRE 15
ADjusTMENT
kNOB 2
INPuT DEvIcE
SwIvEL BRACkET
2" RubbER
wASHER
3/8"x4" GRADE 8
BOLT
AEVIT 2.0 MOUNTING BRACKETS INSTALL MANUAL
FIGuRE 17
2" RubbER
wASHER
ExTENSION
ARM
ADjusTMENT
kNOB 2
FIGuRE 18
3/8" FlAT WAshER
3/8" ROllER bEARING
3/8" FlAT WAshER
3/8" FENDER WAshER
ExTENSION
FIGuRE 15
ARM
FIGuRE 19
2-7