aevit 2.0 Руководство по установке - Страница 8
Просмотреть онлайн или скачать pdf Руководство по установке для Крепление для телевизора aevit 2.0. aevit 2.0 17 страниц. Mounting brackets
Печатать страницуprIMArY INpUT
2.4 gENErIC AdjUSTMENT INSTALLATION
dOOr)
Now that the bases are installed, the adjustment section can now be
mounted. Both the Floor Mounting System and the door Mounting
System will come with the same adjustment section. Therefore, this
section pertains to both installs. The adjustment section comes pre-
assembled from EMC; however, Figures 8 & 9 show exactly how they are
assembled in case you need to disassemble or replace a component. The
main components of the Adjustment Section are the Input Device Ar-
ticulating Swivel Bracket and the quick Adjust Upper Pole (Figure 8). The
main components of the Input Device Articulating Swivel Bracket are the
Input Device Swivel Bracket and the Extension Arm (Figure 9).
INPuT DEvIcE ARTIculAT-
INg SwIvEL BRACkET
QuIck ADjusT uPPER POlE
FIGuRE 8 - ADjusTMENT sEcTION AssEMbly
sTEP 1
Insert the Adjustment Section into either the Floor Base
Plate or the Door Base that was installed in sections 2.2
and 2.3. Adjustment Knob 1 may need to be loosened for
the Adjustment Section to fit into the base. When Adjust-
ment Knob 1 is loosened, it pushes down on the threaded
rod located inside of the quick Adjust Upper Pole. This,
in turn, loosens the wedge at the bottom of the quick
Adjust Upper Pole.
sTEP 2
Once the Adjustment Section Assembly is inserted into
the base, it can be adjusted vertically 4". Once it is at the
correct height, tighten Adjustment Knob 1 thoroughly
(Figure 12). Verify that the quick Adjust Upper Pole will
not move under normal operating conditions.
WARNING:
FAILURE TO TIGhTEN ALL ADjUSTMENT KNOBS
COMPLETELy COULD CAUSE AN ACCIDENT RE-
SULTING IN SERIOUS INjURy AND/OR DEATh.
ADjusTMENT kNOb 1
3/8" FlAT WAshER
3/8" ROllER bEARING
3/8" FlAT WAshER
3/8" FENDER WAshER
2" RubbER WAshER
THREADED ROD
FIGuRE 10 - FlOOR sysTEM
(BrkT-AEVIT-FLr & BrkT-AEVIT
3/8"x4" GRADE 8
BOLT
INPuT DEvIcE
SwIvEL BRACkET
3/8" FENDER WAshER
3/8" FlAT WAshER
3/8" ROllER bEARING
3/8" FlAT WAshER
FIGuRE 9 - INPuT DEvIcE ARTIculATING sWIvEl
BRACkET ASSEMBLY
tighten
adjustMent
knoB 1 to lock
Quick adjust
upper pole
in place
FIGuRE 12 - FlOOR sysTEM
AEVIT 2.0 MOUNTING BRACKETS INSTALL MANUAL
2-5
ADjusTMENT sEcTION
FIGuRE 7
2" RubbER
wASHER
ExTENSION
ARM
ADjusTMENT
kNOB 2
FIGuRE 11 - DOOR sysTEM
ADjusTMENT
SECTION
QuIck ADjusT
uPPER POlE