Duratuf SL1520 Инструкция по сборке Руководство - Страница 14

Просмотреть онлайн или скачать pdf Инструкция по сборке Руководство для Хранение на открытом воздухе Duratuf SL1520. Duratuf SL1520 16 страниц.

SECURING SHED

TIMBER PEGS—WOODEN FLOOR

• The optional Duratuf Timber Peg Down Kit includes six H5 treated timber

pegs that can be hammered into the ground and then attached to the

Base Plate with stainless steel screws. A Sentry timber floor can then be

fitted on top of the Base Plate if required.

BOLT DOWN KIT—CONCRETE

• The optional Duratuf Bolt Down Kit includes 6 x galvanised

brackets, screws and dynabolts.

• Space the brackets evenly around the shed and fix to the Bottom

Plate and the concrete slab. A 10mm masonry drill bit is required.

FITTING A SENTRY FLOOR KIT (OPTIONAL)

• Position the Floor Joists equally between the side Base

Plates and skew nail each end with two 75mm nails.

• Check that the shed is sitting level and square . Check

that the diagonal Bottom Plate measurements are the

same. This ensures that the shed base is square.

• Place the Floor Boards in position. (You may need to cut

the last Floor Board to the correct width using a Skill

Saw.) Nail each Floor Board in, using two 50mm nails

each end and two nails into each floor joist.

FIT PADBOLT

• Rivet Padbolt to door and keeper onto Door Jamb as

shown.

IMPORTANT— CLEAN UP

REMOVE ALL DRILL FILINGS FROM ROOF, WALLS AND CHANNELS THOROUGHLY. FAILURE TO DO THIS

WILL RESULT IN CORROSION AND COULD THEREFORE VOID THE WARRANTY

YOUR DURATUF SENTRY SHED IS NOW COMPLETE. RELAX......

Secure your shed using Treated Timber Pegs or a Bolt Down Kit

BACK BASE PLATE

JOIST

FRONT BASE PLATE