APlusLift HW-10KBP Руководство по установке и эксплуатации - Страница 12

Просмотреть онлайн или скачать pdf Руководство по установке и эксплуатации для Подъемные системы APlusLift HW-10KBP. APlusLift HW-10KBP 20 страниц. 2-post floor plate car lift 10,000lb capacity
Также для APlusLift HW-10KBP: Руководство по установке и инструкции по эксплуатации (16 страниц), Руководство по установке и эксплуатации (20 страниц)

Step 7 (Hydraulic Fluid and Adjustment)

Cable Adjustment

 Place a pair of small or medium vise grips around the shoulder of the long threaded

adjusting bolt on the cable to make any adjustments.

 Use a deep socket to adjust the slack out of the cable. Adjust tension to cables

equality.

 DO NOT over tighten. Note: If one of the cables is tighter than the other, the carriage

will go up uneven. These should be tightened like a banjo string or fan belt.

Hydraulic Fluid

 Remove vent plug from the top of the reservoir. You are going to fill the tank with fluid.

AW 32 or 46 hydraulic oil is recommended. We do not recommend the transmission

fluid as it is too thin. The unit will hold approximately 2.64 gallons (10 liters) of fluid.

 If the arms go all the way to the top, hydraulic oil will flow to two cylinders. If the arms

go all the way to the bottom, hydraulic oil will flow back to the pump.

Carriage Adjustment and Synchronization

 One of the most important things to remember is not to tighten down one side more

than the other. The key is to tighten one side a half dozen turns then the opposite side

a half dozen turns. After getting both cables equally tight (YOU SHOULD BE ABLE TO

MOVE THE CABLES ABOUT AN INCH BACK AND FORTH WITH SLIGHT

PRESSURE LIKE A FAN BELT OR A BANJO STRING) raise the lift all the way up by

pressing the UP Button on the power unit. Do not bottom the lift out at the top by

holding down on the switch.

 Raise the lift off the latch (lock) by pushing the power button, this will enable you to pull

each release cable ring located at the bottom of both carriages. Pull down on the

lowering valve handle (lever) on the power unit and lower the lift all the way to the floor.

Raise the lift again and listen for the clicking of the safety locks in each column.

Determine which side is slower and tighten the adjusting bolt on the opposite side

carriage. Remember to only tighten a few turns at a time until the both locks click at the

same time when raising the lift. Cycle the lift up and down. Repeat the adjustment until

the carriages are within a 1/4" of each other or the clicks are almost at the same time

with each side. When cables are adjusted properly they should be fairly tight.

Safety Latch Adjustment

 If the safety latch in either column does not operate, adjust with the procedure below.

◦ DO NOT set the lift on the safety latch for this adjustment. Allow the hydraulic

system to hold the lift during the adjustment. DO NOT put a vehicle on the lift

◦ Remove the plastic cover. Raise the lift until you can see the latch through the

access hole on the column.

◦ Locate the latch

◦ If the latch is not working during descent, loosen the adjustment bolt one full turn.

Test the latch and follow this procedure until the latch operates.

◦ If the latch is not working during ascent, tighten the adjustment bolt one full turn.

Test the latch and follow this procedure until the latch operates.