Apogee 00524 Руководство - Страница 7

Просмотреть онлайн или скачать pdf Руководство для Игрушка Apogee 00524. Apogee 00524 10 страниц. Fin shape science experiment kit

Печатать страницу

C. Crumple and insert three sheets of

recovery wadding into the body tube.

D. Fold the parachute and insert it into

the tube with the shock cord. Then insert the

nose and payload section onto the tube.

E. Insert the rocket motor into the aft end

of the rocket by bending the clip back slightly

and sliding it in.

F. Insert and secure the engine igniter as

directed on the package the engines came

with.

Countdown and Launch Procedure

Fly your rocket on a large field that isn't

near any power lines, trees, or low flying

aircraft. The larger the field, the greater

your chances of recovering your rocket. The

launch area around the pad must be free of

dry weeds and brown grass. Launch only

during calm weather with very little or no

wind and good visibility.

10. Remove the safety key from the

launch controller.

9. Slide the launch lugs over the launch

rod to place the rocket on the pad. The

rocket should slide freely over the rod.

8. Attach the micro-clips to the igniter.

The clips must not touch each other or the

metal blast deflector.

7. Stand back from your rocket as far as

the launch wire allows (at least 5 meters - 15

feet).

6. Insert the safety key to arm the launch

system. The light (or buzzer) on the control-

ler should come on.

Give a loud countdown 5 ... 4 ... 3 ... 2 ...

1 ... LAUNCH!

Push and hold the the button until the

engine ignites. Then remove the safety key

and place the safety cap on the launch rod.

Misfire Procedure

Occasionally the igniter will burn, but the

motor will fail to ignite. If this happens, the

Spike

Canopy

Roll Sides Inward

Clip over end

of motor

cause is that the pyrogen on the igniter was not in contact with the engines

propellant. When an ignition failure occurs, remove the safety key from the

launch controller and wait 60 seconds before approaching the rocket. Re-

move the old igniter from the engine and install a new one. Make sure that

the igniter is insert fully into the engine and touches the propellant. Secure

the igniter as directed on the engine package and repeat the countdown

and launch procedure.

Always follow the NAR* Model Rocket Safety Code when launching

model rockets.

*National Association of Rocketry

**Kevlar

is a brand name of E.I. DuPont for their selection of aramid fibers. Only DuPont makes Kevlar

Fold

Peak

Down

Lay Excess String

on Top of Canopy

Loosely Wrap Any

Excess String around

Canopy And Insert

Page 7