Apogee 00524 Посібник - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник для Іграшка Apogee 00524. Apogee 00524 10 сторінок. Fin shape science experiment kit
C. Crumple and insert three sheets of
recovery wadding into the body tube.
D. Fold the parachute and insert it into
the tube with the shock cord. Then insert the
nose and payload section onto the tube.
E. Insert the rocket motor into the aft end
of the rocket by bending the clip back slightly
and sliding it in.
F. Insert and secure the engine igniter as
directed on the package the engines came
with.
Countdown and Launch Procedure
Fly your rocket on a large field that isn't
near any power lines, trees, or low flying
aircraft. The larger the field, the greater
your chances of recovering your rocket. The
launch area around the pad must be free of
dry weeds and brown grass. Launch only
during calm weather with very little or no
wind and good visibility.
10. Remove the safety key from the
launch controller.
9. Slide the launch lugs over the launch
rod to place the rocket on the pad. The
rocket should slide freely over the rod.
8. Attach the micro-clips to the igniter.
The clips must not touch each other or the
metal blast deflector.
7. Stand back from your rocket as far as
the launch wire allows (at least 5 meters - 15
feet).
6. Insert the safety key to arm the launch
system. The light (or buzzer) on the control-
ler should come on.
Give a loud countdown 5 ... 4 ... 3 ... 2 ...
1 ... LAUNCH!
Push and hold the the button until the
engine ignites. Then remove the safety key
and place the safety cap on the launch rod.
Misfire Procedure
Occasionally the igniter will burn, but the
motor will fail to ignite. If this happens, the
C
1
Spike
Canopy
D
Roll Sides Inward
Clip over end
of motor
E
F
cause is that the pyrogen on the igniter was not in contact with the engines
propellant. When an ignition failure occurs, remove the safety key from the
launch controller and wait 60 seconds before approaching the rocket. Re-
move the old igniter from the engine and install a new one. Make sure that
the igniter is insert fully into the engine and touches the propellant. Secure
the igniter as directed on the engine package and repeat the countdown
and launch procedure.
Always follow the NAR* Model Rocket Safety Code when launching
model rockets.
*National Association of Rocketry
**Kevlar
is a brand name of E.I. DuPont for their selection of aramid fibers. Only DuPont makes Kevlar
®
2
Fold
Peak
Down
Lay Excess String
on Top of Canopy
5
4
Loosely Wrap Any
Excess String around
Canopy And Insert
3
®
Page 7