Data Aire dap4 touch Краткое руководство по эксплуатации - Страница 6

Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Системы управления Data Aire dap4 touch. Data Aire dap4 touch 9 страниц. Modbus tcp/ip protocol integration
Также для Data Aire dap4 touch: Руководство пользователя (8 страниц), Инструкции по установке (2 страниц), Руководство по протоколу (13 страниц)

This is a view only menu detailing the processor version and requires the service level password to enter.

Menu allows programming of available protocols. Typically this menu is factory set.

Requires a service level password for programming

Allows calibration of the installed unit sensors if required

Requires a service level password for programming

Allows the unit components to run manually. Used for diagnostic of individual components within the unit.

Requires a service level password for programming

Menu J is for setting the control to the type equipment and options ordered. This includes compressor type and quan-

tity, blower type, blower running speed or mode, chilled water valve type, Energy Saver, humidifier, reheat and other

additional features. This requires the Factory Level password and entry should be limited to Data Aire factory and

service personnel.

Menu K is for setting the control alarms, limits, alarm enunciation mode, configure optional and custom alarms.

Firestat alarm will shut unit down, its limit is programmed at 150°F as default value. (150 Deg F is default in software

version 1.25 or later. 100 Deg F is default value in older software version.) Change this limit on start-up if necessary.

This requires a service level password for programming

Menu L is a factory menu for configuring the unit's digital inputs and the unit's analog inputs and outputs. This re-

quires the Factory Level password and entry should be limited to Data Aire factory and service personnel.

Menu F - Information

Menu G – Network Config

Menu H – Calibrate Sensors

Menu I – Manual Control

Menu J – Factory Settings

Menu K – Alarms & Limits

RETURN AIR ALARMS

Firestat Set Point:

Hi Temp Alarm:

Setpoint:

Low Temp Alarm:

Setpoint:

Menu L – Configure I/O

150°F

Yes

80°F

Yes

60°F