DURRIDGE RAD7 Руководство по подключению - Страница 4

Просмотреть онлайн или скачать pdf Руководство по подключению для Измерительные приборы DURRIDGE RAD7. DURRIDGE RAD7 4 страницы. Passive, slow response radon in water accessory
Также для DURRIDGE RAD7: Руководство по подключению Bluetooth (4 страниц), Руководство пользователя (7 страниц), Руководство пользователя (15 страниц)

Figure 2: ParaniWin UART Setting Dialog (Left) and Device Setting Panel (Right). These windows

are used to locate the SD1000 adaptor and conﬁgure the adaptor, respectively. Controls marked with

red arrows must be modiﬁed from their factory defaults in order for the SD1000 to function properly

with the RAD7.

6. After clicking OK in the UART Setting dialog, select the Device Setting panel, as shown in Figure 3,

above. Set the controls as follows:

• S et the Operation Mode to MODE3 (Allow any Bluetooth devices to discover/connect to this

Parani-SD).

• Set the Device Name to "SD1000-Bluetooth" or a similarly recognizable name.

• Check the Authentication checkbox, and enter 0000 in the Pin Code ﬁeld. Uncheck the

Encryption checkbox.

• Set Command Response to OFF. This makes it possible for the SD1000 adaptor to operate

without disrupting the RAD7. Note: If Command Response is left ON, the RAD7 will be ﬂooded

with unusable serial data and it may become corrupted and inoperable.

• Make sure the Baud Rate is 9600, Parity is None, and Stop Bit is 1.

7. After specifying the proper settings, click the Apply button, and wait for the settings to be saved.

8. Exit ParaniWin. Switch OFF the SD1000 adaptor and unplug it from the computer. It is now

properly conﬁgured ready for future use with the RAD7.