4O3A Rotator Genius Руководство - Страница 10

Просмотреть онлайн или скачать pdf Руководство для Контроллер 4O3A Rotator Genius. 4O3A Rotator Genius 20 страниц.

Печатать страницу
Lastly a 12V PSU configuration would look like. DIP7 and DIP8 set power with 100% voltage:
In order to verify you connected the rotors correctly, use the CW and CCW buttons on the device control your
rotor manually. Use Select to switch between the selected rotators.

3.8.2 Low Range AC Rotors

Low range AC motors are AC motors that use between 3V and 48V.
RG can convert the supplied DC power to AC for powering rotor motors.
Make sure to set DIP6 to ON to supply AC voltage.
Common wire is connected to PIN3 (pins are counted from left to right).
CW and CCW lines are connected to PIN1 and PIN2.
If you swap CW and CCW lines you can use DIP2 to reverse them in software rather then rewire.
DIP7 and DIP8 are configured to 100% voltage in this example. This will vary depending on your setup.
⬆
Back to table of contents
Page 10