4O3A Rotator Genius Руководство - Страница 12

Просмотреть онлайн или скачать pdf Руководство для Контроллер 4O3A Rotator Genius. 4O3A Rotator Genius 20 страниц.

3.8.4 Prop Pitch Motors

Common wire is connected to PIN2 (pins are counted from left to right).

CW and CCW lines are connected to PIN1 and PIN3.

Make sure to set DIP3 to ON, this specifies the special case Prop Pitch motor.

Set DIP1 to ON to configure the motor as DC.

DIP7 and DIP8 are configured to 100% voltage in this example. This will vary depending on your setup.

Use the

and

CCW

buttons to move your rotor manually to ensure proper connections/configuration has been

made.

Use the

Select Rotator

button to switch between the rotors.

An arrow on the most left on the LCD screen is the indication of the selected motor.

Sensors read the magnetic azimuth and send the position to the RG. Sensors are carefully calibrated in the

factory and you can use them out of the box.

The arrow on the sticker shows the direction it is pointing.

This sensor must be as parallel to the ground as you can get it- not tilted at all.

Place the Sensor at least 80cm away from any metal materials and

ferromagnetics.

You can mount it to the aluminum antenna boom.

The sensor is placed in a plastic waterproof housing.

It is very light so you can use plastic cable strips for mounting.

In order to connect the sensor open it by unwinding the four screws on the box.

Data is sent over UTP network cable using the RS485 protocol.

Two wires are used for VDC, two wires for GND and single wires in A and B for data.

⬆

Back to table of contents

Page 12