Aussie Pumps AB Scud 40 Руководство по эксплуатации - Страница 9

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Мойка высокого давления Aussie Pumps AB Scud 40. Aussie Pumps AB Scud 40 16 страниц. Stainless steel frames, 3,000/4,000 psi
Также для Aussie Pumps AB Scud 40: Руководство по эксплуатации (16 страниц)

Печатать страницу

Feb 2019

Using Foamer

(supplied with AB30 hose reel version)

1. Using brass nipple supplied (C1500.06, M22 x

¼M), attach foaming nozzle to the gun in place of

Vario lance.

2. Prepare pressure washer detergent solution as

required by manufacturer.

3. Fill foamer bottle and screw into foamer nozzle.

Ensure siphon tube is attached inside bottle.

4. Spray angle can be adjusted by rotating the nozzle

cover. The amount of foam delivered is adjusted

with the knob on top.

5. Apply cleaning solution to a dry surface, starting at

lower portion of areas to be washed and work

upward, using long overlapping strokes.

6. Allow time for foam to activate and then rinse off.

DO NOT allow foam to dry on.

IMPORTANT: rinse foamer nozzle & bottle with clean

water after every use to prevent clogging.

FOAMER APPLIES DETERGENT TO DISOLVE GREASE

(applied at low pressure)

Aussie AB Direct Drive Super Scud Series ... Operation & Maintenance Manual

Stopping the machine

1. If using the detergent injector, flush out the

chemical by running clean water through the

system.

2. Allow machine to run for 1 minute without load

to cool before stopping.

3. Turn engine ON/OFF switch to OFF

4. Pull recoil start until compression resistance is

felt. Store the machine in this position to help

prevent valve warpage or sticking.

5. Close fuel valve.

FAILURE TO CLOSE THE FUEL VALVE ON THE

ENGINE CAN CAUSE FUEL LEAKAGE WHEN THE

MACHINE IS BEING TRANSPORTED!

6. Turn off water supply.

7. Pull gun trigger to release all pressure in the

system, then LOCK THE TRIGGER.

8. Hoses may now be disconnected from the

machine.

Failure to release pressure before disconnecting the

hose quick coupler will result in the quick coupler o-

ring seal blowing out. This o-ring must be replaced

before operating machine.

CLEAN FASTER WITH A FLAT SURFACE CLEANER

Aussie Pumps