dymax 485 Руководство пользователя - Страница 9

Просмотреть онлайн или скачать pdf Руководство пользователя для Блок управления dymax 485. dymax 485 16 страниц. Needle valve
Также для dymax 485: Руководство пользователя системы (16 страниц), Руководство пользователя (16 страниц)

Adjusting Material Flow

Flow can be adjusted using the Flow Adjustment Knob. Turn the knob clockwise to

decrease the flow or counterclockwise to increase flow.

Plumb up the valve as outlined in the setup procedures.

Apply air pressure by turning on the pressure to the controller.

If necessary, place a new dispense tip onto the valve.

Apply fluid pressure to the valve by turning on the pressure to the material

reservoir.

Cycle the valve to the open position to bleed all air that may have become

trapped when changing the dispense tip. You may need to tip the valve up to 60°

incline and continue cycling the air to remove it all.

Check the fluid connection for leaks. If the valve is leaking or dripping, refer to the

troubleshooting section of this manual.

With the flow adjustment knob backed off counterclockwise 3 or 4 turns and the

dispense tip in place, adjust the air pressure on the fluid (the valve will be in the

open dispense position). Use the flow adjustment knob to reduce the material

flow until the desired flow rate is achieved.

At the end of the day or shift, it is necessary to shut down the Model 485 dispensing

system properly in order to keep material from curing inside the dispensing valve.

Remove the disposable dispense tip from valve and discard.

Relieve fluid pressure on the valve by turning off air pressure at the material

reservoir.

Relieve the air pressure operating the valve by turning off the air pressure to the

controller.

Model 485 Dispensing Valve User Guide