Gage Bilt GB713 Руководство по установке - Страница 8

Просмотреть онлайн или скачать pdf Руководство по установке для Инструменты Gage Bilt GB713. Gage Bilt GB713 14 страниц.
Также для Gage Bilt GB713: Оригинальное руководство по эксплуатации (18 страниц), Оригинальное руководство по эксплуатации (20 страниц)

TROUBLESHOOTING

Providing all maintenance conditions have been met, follow this systematic approach to diagnosis.

1. MORE THAN ONE PULL IS REQUIRED TO BREAK RIVET.

Tool needs to be bled. (See filling and bleeding instructions.)

Spring has fatigued, replace.

Jaws are stripped or packed with chips. Clean or replace.

Incorrect nose tip.

2. SLOW OR PARTIAL OPERATION WHEN THE AIR ACTUATOR ASSY (704130) IS DEPRESSED

Polyseal (A-1119) and o'ring (400793) on the piston (713211) could be worn or damaged. Replace.

Back-up ring (S908) and o'ring (A-201) on the piston rod assy (744136) could be worn or damaged. Replace.

Muffler (744143) or filter inside valve spool assy (743142) may be plugged with dirt. Clean thoroughly and back-blow

with compressed air.

Hole in metering screw in valve spool assy (743142) may be blocked or damaged. Hole diameter should be .028". Clear

and size or replace.

3. NO OPERATION WHEN AIR ACTUATOR ASSY (704130) IS DEPRESSED

Tool seized due to mechanical failure or damaged parts.

4. OIL LEAKAGE

DO NOT

OPERATE WITH OIL LEAKING FROM TOOL. HIGH PRESSURE OIL MAY CAUSE SEVERE PERSONAL INJURY.

Any oil leaking externally should be traced to its source. An o'ring or seal that leaks should be replaced.

5. AIR BYPASS FROM VALVE HOUSING

If the spring (744144) breaks or dislodges, air will flow freely through the muffler (744143). Replace or reset. Valve

spring installation tool (704162) is recommended.

Check o'rings on valve sleeve (743144), valve spool assy (743142), and valve plug (744142). If worn or damaged,

replace. Valve sleeve removal tool (744152) is recommended.

6. FASTENER STEM JAMMED IN NOSE ASSEMBLY

Nose assembly components require service.

disassemble. Replace worn or broken parts. Clean the surface the jaws ride on.

Stems lodged side by side in the follower. Disassemble, remove stems, and reassemble.

Incorrect follower.

DISCONNECT AIR FROM

TOOL, remove the nose from the tool and

7/11 REV 10/14