Gage Bilt GB713 Руководство по установке - Страница 9
Просмотреть онлайн или скачать pdf Руководство по установке для Инструменты Gage Bilt GB713. Gage Bilt GB713 14 страниц.
Также для Gage Bilt GB713: Оригинальное руководство по эксплуатации (18 страниц), Оригинальное руководство по эксплуатации (20 страниц)
Печатать страницу
OVERHAUL
WARNING:
Disconnect tool from its air source before performing overhaul.
WARNING:
Tool must be maintained in a safe working condition at all times and examined on a daily basis for damage or
wear. Any repair should be done by qualified personnel trained on Gage Bilt procedures.
WARNING:
When operating, repairing or overhauling tool, wear approved eye protection. Do not look in Front of tool or rear
of tool when installing fastener.
WARNING:
Depress actuator lever assy and disconnect from air, with the piston in the rear position, before overhaul.
Severe personal injury may occur if air hose is not disconnected.
assembly downward with head cylinder removed. Hydraulic oil will eject forcibly from handle assy.
The disassembly and re-assembly procedure can be accomplished by utilizing the following instructions and drawings. Use extreme
care during disassembly and re-assembly not to mar or nick any smooth surface that comes in contact with seals. Before installing
seals, always apply a good lubricant, such as Lubriplate®, to the surfaces. It is recommended that tool kit (GB740TK) be used to facil-
itate overhaul. A complete overhaul can be achieved by the use of Service Kit (713122) which contains a complete set of o'rings, back
-up rings, screws, washers and gasket. It is recommended that this service kit be kept available for spare parts.
704214 STEM CATCHER BAG
REMOVING 704130 AIR ACTUATOR ASSY
CAUTION:
Air actuator assy can break if not careful.
1.
Insert a 5/8" (15.9 mm) open end box wrench around air actuator assy (704130).
2.
Loosen the air actuator assy (704130).
3.
Remove wrench. Unthread and remove the air actuator assy (704130) with
fingers from the handle assy (744129).
INSTALLING 704130 AIR ACTUATOR ASSY
CAUTION:
Do not over tighten air actuator assy. Snug tighten only.
1.
Apply Teflon® tape onto threads of air actuator assy (704130) one to two wraps.
2.
Thread the air actuator assy (704130) all the way into handle assy (744129) with fingers.
3.
Insert and turn 5/8" (15.9 mm) wrench and snug tight approximately 1/4-1/2 turn.
704151
POWER CYLINDER TOOL
704149
PISTON ROD WRENCH
(704214 CATCHER BAG SHOWN ABOVE IS SOLD SEPARATELY)
GB740TK Service Tool Kit Includes:
Part No.
704149
704150
704151
704152
704153
S1178
744251
744152
704152
SEAL GUIDE
704150
PACKING PLUG WRENCH
BLEEDER BOTTLE
Description
Piston Rod Wrench
Packing Plug Wrench
Power Cylinder Tool
Seal Guide
Air Bleeder Ass'y
Valve Extractor
Valve Spring Installation Tool
Valve Sleeve Removal Tool
9
USE CAUTION
when forcing piston rod
744251
VALVE SPRING
INSTALLATION TOOL
744152
704153
VALVE SLEEVE
REMOVAL TOOL
S1178
VALVE EXTRACTOR
7/11 REV 10/14