Active SmartHome Repeater Руководство по установке и эксплуатации - Страница 9
Просмотреть онлайн или скачать pdf Руководство по установке и эксплуатации для Ретранслятор Active SmartHome Repeater. Active SmartHome Repeater 15 страниц. Active smarthome system
2. 2. 2. 2.
Press the Test button (button 5 under the module cover) on the back, so that
the Repeater transmits a learning signal to the Active SmartHome Gateway.
The red LED lights up and the device emits 1 beep.
3. 3. 3. 3.
If the Repeater receives an acknowledgement signal from the Active
SmartHome Gateway within 60 seconds, the learning procedure has been
successful. The Blue LED will light up for one second and the device emits a
long beep. If the Repeater fails, this will be indicated by the yellow LED
flashing 3 times and you will then have to repeat the procedure.
4. 4. 4. 4.
Move DIP Switch 4 to the OFF position. The Repeater will then emit 1 long
beep and the yellow LED will fade as the Repeater returns to Normal Mode.
3 3 3 3 .2. .2. .2. .2. Repeater
Repeater
Repeater
Repeater Learn Procedure
Learn Procedure
Learn Procedure
Learn Procedure
Before pairing your devices with the Repeater, make sure you have already paired
them with the Active SmartHome Gateway (please follow the User Guide for the
sensor in question). Once you have done this, use the following procedure:
1. 1. 1. 1.
Under Normal Mode, slide DIP Switch 1 to ON and wait until it emits a long
beep and the yellow LED flashes slowly (1 flash every 2 seconds).
R e p e a t e r
F i g u r e 0 2
R e p e a t e r i n t h e S e t t i n g s p a g e
I ns t a l l a t i on a nd O pe ra t i o n G ui d e
I ns t a l l a t i on a nd O pe ra t i o n G ui d e
I ns t a l l a t i on a nd O pe ra t i o n G ui d e
I ns t a l l a t i on a nd O pe ra t i o n G ui d e
P a g e | 9