Great Lakes MINISTAR S Поиск и устранение неисправностей и советы по изготовлению - Страница 2

Просмотреть онлайн или скачать pdf Поиск и устранение неисправностей и советы по изготовлению для Стоматологическое оборудование Great Lakes MINISTAR S. Great Lakes MINISTAR S 2 страницы.
Также для Great Lakes MINISTAR S: Руководство по эксплуатации (13 страниц)

Печатать страницу

Great Lakes MINISTAR S Поиск и устранение неисправностей и советы по изготовлению

MiniSTAR S with Scan Technology Maintenance Tips

Pellets will become dirty with regular use.

Clean pellets by placing them in a strainer

and rinsing with hot water. Spread pellets

on a towel and let air dry before placing

them back in the MiniSTAR S. Check pellets

monthly. Discard and replace pellets in the

bottom third of the cup.

Clean and inspect top of the

chamber sealing ring (A) and

side gasket (B) every 4-6

months. Clean gasket with a

soft cloth. Check potential

gasket cuts or irregularities.

Adjusting ring should move freely

in the chamber. If not, apply a thin

coat of Silicone Grease (016-021)

to outer ring of the chamber (A),

4 spring-loaded adjusting pins (B),

and outside edge of adjusting ring

(C).

A regular maintenance schedule should be followed. Proper

maintenance will assure better fabrication results. Refrain

from using water in the MiniSTAR S machine. Water may

cause certain components to rust or corrode. When the

machine is not being used, engage the clamping frame to

the chamber and position the chamber on the pellet cup.

This prevents lab dust from entering the pellet cup and

chamber.

Air escape holes are present in the base of the pellet cup and

should be checked monthly to ensure that they remain open.

Use a .036" diameter or smaller wire to open plugged holes.

SMPP67Rev121611

Check the air filter clamped

to air line monthly for discol-

oration and/or moisture. If

replacing the filter, turn off the

air source and bleed the high-

pressure hose of air. Loosen

clamps holding the filter and

slide it off the hose. Position

the new filter by referencing

the arrow on the filter case

toward the back of the

MiniSTAR S.

1.800.828.7626

greatlakesortho.com

S-302

The heating surface (A) should

be parallel to the heating

element (B). Adjust the position

of the chamber by turning the

screw (C) located under the

chamber support frame with

a small screwdriver. Clockwise

adjustment of the screw lowers

the chamber from the heater,

counter clockwise raises the

chamber closer to the heater.

Check the position of the

chamber when heating

materials.