ADELSYSTEM CBI-1280 Series Руководство - Страница 5

Просмотреть онлайн или скачать pdf Руководство для Источник питания ADELSYSTEM CBI-1280 Series. ADELSYSTEM CBI-1280 Series 11 страниц. All in one dc ups power solutions

Печатать страницу

No. 6, 7 and 8 Display Signals

No.6: Led MAINS OR BACKUP: Input Mains On/Off

No.7: Led BATTERY FAULT (capacity less than 30%), Fault connections systems, Battery replacement.

No.8: Led DIAGNOSIS Battery charge mode, diagnosis of the system through "blinking code" signal.

Monitoring

Control

State

Chart:

Trickle

Charging

Absorption

Type

Boost

Recovery

Reverse polarity or high battery Voltage (over 32.5Vdc for

24V)

Battery No connected

Element in Short Circuit

Over Load or short circuit on the load

Auto

Bad battery; Internal impedance Bad or Bad battery wire

diagnosis

connection.

of the

Life test not possible

system

Bad thermal sensor

Boost condition; battery discharge after 4 min. of overload. 8 Blink/pause

Internal fault or illegal configuration jumper

Low battery (under 18.5Vdc for 24V) Only if started from

battery, no Main input. Form Input N°12 or Push Bottom

MOD BUS error

No. 9, 12: BATTERY START, No MAINS Vac

No. 9: Push-button, for 3 sec., in the front panel for switch ON the system without the "MAINS input Vac" but

only the battery connected.

No.12: It is also available the same function for remote Start from the battery, via RTCONN cable with 2

poles connector to put in Input N°12 and use with a Push button or a normaly open contact. Do not insert a

jumper in this position, penalty discharge completely the battery close to Zero in BACKUP.

No. 17: Battery Management Configurations

One device for all battery types.

Completely automatic, all devices are suitable to charge most

batteries types thank to User Selectable charging curves. They can

charge open lead acid, sealed lead acid, Gel and Ni-Cd batteries. It

is possible to change or add other charging curves connecting the

device to a portable PC.

Caution: Switch off the system before Setting the jumper.

For Battery Type Selection always refer to the data of the

Battery Type

Selection

Open Lead

VRLA (AGM) "1"

Gel Battery "2"

Ni-Cd "3"

(1)

Deep Switch Position

BATTERY TYPE

Point of view

manufacturer of the batteries.

Trickle/Float

charge

(Volt/Cell)

2.23

2.25

2.30

10% Imax Trimmer

LED Diagnosis

(No.8)

1 Blink/2 sec

1 Blink/sec

2 Blink/sec

5 Blink/sec

1 Blink /pause

2 Blink/pause

3 Blink/pause

4 Blink/pause

5 Blink/pause

6 Blink/pause

7 Blink/pause

9 Blink/pause

10 Blink/pause

11 Blink/pause

BATTERY TYPE

LIFE TEST

ENABLE POWER SUPPLY

Fast/Bulk charge

(Volt/Cell)

2.40

1.70–(12V);1.5–(24V)

LED Battery

Fault (No.7)

OFF