ADEMCO 4110XM Руководство по установке - Страница 9

Просмотреть онлайн или скачать pdf Руководство по установке для Система безопасности ADEMCO 4110XM. ADEMCO 4110XM 20 страниц.

• Use the House ID Sniffer mode to select a House ID that is not being used in a nearby system

as follows:

a. Enter the [Master Code] + [#] +[2].

While in this mode, the keypad will display the House ID transmitted by any wireless

devices in the area. It may take some time for all wireless devices in the area to send a

signal, so it is recommended that you leave the system in this mode for approximately 2

hours. If any House ID numbers are displayed, select another number for this system.

IMPORTANT

b. Exit this mode by entering the [Master Code] + [1] OFF.

5. Install Sounding Devices

U L

IMPORTANT

7. Connect the Telephone Line

IMPORTANT

8. Connect the AC Transformer

• Use the wiring table at the end of this section for maximum wire lengths per gauge.

WARNING

IMPORTANT

U L

• Connect Terminal 21 to a good earth ground (Metal Cold Water Pipe, or AC Power Outlet

Ground from a 3 prong, 120VAC outlet. This is necessary for the lightning protection

devices in this control to work properly.

Remove all batteries from transmitters before going into the House ID

Sniffer Mode.

Use only UL Listed sounding devices for UL installations.

When using a keyswitch, the system cannot support wireless.

Make sure telephones on the premises are connected only through the

alarm control panel (disconnect from the incoming phone line at the

telephone jack). This is necessary to have true line seizure.

DO NOT PLUG THE TRANSFORMER INTO THE AC OUTLET UNTIL

ALL OTHER WIRING TO THE CONTROL IS COMPLETE.

Do not attach the connector cable to the battery's terminals until

after you have plugged the AC transformer into an uninterrupted

120VAC outlet.

1. In UL installations, maximum current draw from the Auxiliary

Output and the Alarm Output combined must not exceed 600mA.

2. Use a 3A battery or larger for UL installations.

-9-