Hi-Z Antennas Shack Switch-2 Руководство - Страница 9
Просмотреть онлайн или скачать pdf Руководство для Приемник Hi-Z Antennas Shack Switch-2. Hi-Z Antennas Shack Switch-2 12 страниц. Receiving array controller with an oled display
Печатать страницу
Hi-Z Receiving Array Shack Switch Using an OLED Display
The
"Display
values of brightness available with the factory default value being BI=2. To access the
"Display Brightness" function depress the Hi-Z knob and rotate the knob until you see
"Display Brightness". Depress the knob again and the screen will change to where you
can see "BI" and a "BV" values. Rotate the knob to change between the 5 BI values
available. This is no place for "All Knobs To The Right". The factory default is BI=2 and
in normal room light the display is quite readable. Again, these OLED displays are new
and the lifetime is unknown so be gentle with your selection of BI value. Depress the
knob and you will return to the normal Direction display screen.
4.8.
Rly Test, Walking 1s
The
"Rly Test Walking
user to verify switched outputs quickly. This function allows all 6 of the switched outputs
to be switched to ground in a sequential manner. The outputs will switch for a 1 second
period then advance to the next higher output connector number. It will continue to
switch through this sequence until stopped. To enable this function depress the Hi-Z
knob and then rotate it until the "Rly Test Walking 1s" function is displayed. Depressing
the knob again will start the function. Depressing it again will terminate the test.
4.9.
Rly Test, Val
This function is a quick way to activate any one of the 6 switches at the
output connector. As you rotate the Hi-Z knob when this function is enabled the unit will
switch any of the available outputs to an on state for testing purposes. To select this
function, depress the Hi-Z knob and rotate it until the
Depress the knob again and then when you rotate the knob you can select any
individual output switch to an on state. Depressing the knob again disables this function
and returns you to the direction readout screen. This is a way to test or activate the
unused outputs depending on the array you have chosen.
4.10.
Display Volts
Brightness" function does exactly what it says. There are 5
1's" function is a diagnostic test mode that allows a
Hi-Z Antennas Shack Switch 2 Rev.1 10-13-2019
"Rly Test,
10
Val" function shows.