Hi-Z Antennas Shack Switch-2 Руководство - Страница 8
Просмотреть онлайн или скачать pdf Руководство для Приемник Hi-Z Antennas Shack Switch-2. Hi-Z Antennas Shack Switch-2 12 страниц. Receiving array controller with an oled display
Печатать страницу
Hi-Z Receiving Array Shack Switch Using an OLED Display
dot in the bottom right corner of the display that lights when the Aux function is enabled
as shown on page 4 of this document.
4.5.
Display Top
The "Display Top" function allows the user to select what information is
displayed at the top right corner of the Yellow part of the display. One selection is
Type" and is to display the array type selected by the operator. The second function
"Act
Pos" and is to display the actual array direction in Degrees when an array is
physically mounted offset from usual compass directions and the offset function is
used. The third function
the compass direction in Degrees. Another function is "Relay" which will display the
actual on or off condition for whatever direction is selected of all the switched outputs
used for the Antenna type selected. The last function is "None" which leaves that top
right corner blank.
4.6.
Display Off
The
"Display
saver will take before turning the display to a dim single dot jumping around the screen.
The time can be set for many values between 15 minutes and three hours. It can even
be disabled by this function. These organic screens are new technology and their
lifetime may be affected by long term high brightness use. Especially if the Brightness is
set to higher than a 3 level. To be on the safe side we have included the screen saver
function. To select the time of the screen saver time out or to disable it depress the Hi-Z
knob and rotate it until you see the "Display Off" function. Depress the knob again and
the current value of time will be displayed. Rotating the knob will then bring up all the
values available including the "Disabled" one. Select the value you want and depress
the knob again and you will be back to the Direction readout screen.
4.7.
Display Brightness
"Req
Pos" is to display the requested position which will read
Off" function allows the user to set the time that the screen
Hi-Z Antennas Shack Switch 2 Rev.1 10-13-2019
9
"Ant