Hi-Z Antennas Shack Switch-2 Manuel - Sayfa 8

Alıcı Hi-Z Antennas Shack Switch-2 için çevrimiçi göz atın veya pdf Manuel indirin. Hi-Z Antennas Shack Switch-2 12 sayfaları. Receiving array controller with an oled display

Sayfayı Yazdır

Hi-Z Receiving Array Shack Switch Using an OLED Display

dot in the bottom right corner of the display that lights when the Aux function is enabled

as shown on page 4 of this document.

4.5.

Display Top

The "Display Top" function allows the user to select what information is

displayed at the top right corner of the Yellow part of the display. One selection is

Type" and is to display the array type selected by the operator. The second function

"Act

Pos" and is to display the actual array direction in Degrees when an array is

physically mounted offset from usual compass directions and the offset function is

used. The third function

the compass direction in Degrees. Another function is "Relay" which will display the

actual on or off condition for whatever direction is selected of all the switched outputs

used for the Antenna type selected. The last function is "None" which leaves that top

right corner blank.

4.6.

Display Off

The

"Display

saver will take before turning the display to a dim single dot jumping around the screen.

The time can be set for many values between 15 minutes and three hours. It can even

be disabled by this function. These organic screens are new technology and their

lifetime may be affected by long term high brightness use. Especially if the Brightness is

set to higher than a 3 level. To be on the safe side we have included the screen saver

function. To select the time of the screen saver time out or to disable it depress the Hi-Z

knob and rotate it until you see the "Display Off" function. Depress the knob again and

the current value of time will be displayed. Rotating the knob will then bring up all the

values available including the "Disabled" one. Select the value you want and depress

the knob again and you will be back to the Direction readout screen.

4.7.

Display Brightness

"Req

Pos" is to display the requested position which will read

Off" function allows the user to set the time that the screen

Hi-Z Antennas Shack Switch 2 Rev.1 10-13-2019

"Ant