Hi-Z Antennas Shack Switch-2 Manuel - Sayfa 10

Alıcı Hi-Z Antennas Shack Switch-2 için çevrimiçi göz atın veya pdf Manuel indirin. Hi-Z Antennas Shack Switch-2 12 sayfaları. Receiving array controller with an oled display

Sayfayı Yazdır

Hi-Z Receiving Array Shack Switch Using an OLED Display

This function allows the user to measure the voltage supplied by the USB

power source. It allows you to make sure the source and the cable in use is supplying

the proper 5 Volts as it should. To select this function depress the Hi-Z knob and rotate

it until you see

"Display

voltage being supplied by the power source and cable. Depressing the knob again

disables this function and returns the unit to the direction display screen. The voltage

reading should be between 4.50 and 5.25 Volts DC. Values lower than this may be an

indication of a bad USB cable and normal operation may be negatively affected.

4.11

Enable Flip

The "Enable Flip" function allows the operator to select the opposite 180

degree direction of an array to be selected with a simple depression of the Hi-Z knob.

The knob can be repeatedly pressed after the function is enabled to flip back and forth

between two 180 degree different directions until this function is disabled. To enable

this function depress the Hi-Z knob while in the normal direction readout screen which

will bring up the function directories again. Rotate the direction knob until

is displayed. Press the knob again and you will see the current state of the function.

Rotate the knob until you see the Enable the flip function. Depress the knob again and

you will be returned to the normal direction readout screen. Now you can repeatedly

press the knob causing the array to shift between two 180 degree different directions.

You can still rotate the direction control and flip between two different 180 degree flip

directions. To stop this function depress the Hi-Z knob for 3 seconds. When you let the

knob up it will return the controller to the Direction screen.

4.12

Auto Rotate

The "Auto Rotate" function allows this controller to continuously step to

each available direction automatically. It can rotate "CW" for clockwise with the array

viewed from above or "CCW" for counterclockwise viewed from the top. Again to enable

this function, press the Hi-Z knob and rotate it until the

displayed. Press the knob again and rotate the knob for three choices "CW", "CCW", or

"Stop". Select the direction you want and again press the knob and you will return to the

Direction display screen with "Auto Rotate" enabled. The controller will continue to step

Volts". Press the knob again and the unit will show the actual

Hi-Z Antennas Shack Switch 2 Rev.1 10-13-2019

"Auto

"Enable

Rotate" function is

Flip"