Aircraft in Miniature Limited Historic Wings Инструкция по сборке Руководство - Страница 8
Просмотреть онлайн или скачать pdf Инструкция по сборке Руководство для Игрушка Aircraft in Miniature Limited Historic Wings. Aircraft in Miniature Limited Historic Wings 10 страниц. 1:72 metal kit of the 1906 santos dumont 14 bis
Печатать страницуC Put the left wing assembly in position. Engage the slots in the wing spars with
those in the wing ribs and attach the right wing assembly. Bond the joints and leave
the assembly until the adhesive has cured.
D Make sure it is straight, then cut a length of stainless steel wire to make the
elevator pivot. Put it through the holes in the centre of the rudders and the lugs on
the forward edge of the fuselage structure.
6 LANDING GEAR AND DETAIL PARTS ASSEMBLY (See Figure 9)
A Remove these components from the frets and remove any burrs from the
attachment tags:
-
Control column
-
Elevator control centre
-
Four exhaust manifolds
-
Fuel tank support
-
Tailwheel arm
-
Tailwheel leg
-
Two elevator control frames.
PROPELLER
A R
R W
F O
BALLAST
TAILWHEEL LEG
B Engine, drive shaft and propeller
(1) Drill 0.75mm/.03" diameter holes in the rear face of the propeller hub and the
aft face of the engine for the ends of the drive shaft.
(2) Attach the four exhaust manifolds to the top of the engine.
(3) Attach the engine to the engine bearers.
(4) Make sure the wire is straight, then cut a length to make the drive shaft. Use the
distance from the installed engine to the end of the fuselage as a guide for the
length.
(5) Attach the drive shaft and propeller.
C Attach the two ballast tanks adjacent in the fuselage.
D Main wheels.
(1) Cut a piece of wire for the main wheel axle, or use a dressmakers pin (not
supplied in this kit).
FOUR EXHAUST
MANIFOLDS
DRIVE SHAFT
D
TANKS
TAILWHEEL
ASSEMBLY
FUEL TANK
FUEL TANK
SUPPORT
ENGINE
TAILWHEEL ARM
TAILWHEEL AXLE
Figure 9
CONTROL
COLUMN
ELEVATOR
CONTROL
FRAMES
ELEVATOR
CONTROL
- CENTRE
OIL TANK
MAINWHEEL
AXLE
MAINWHEEL
ASSEMBLY