Aircraft in Miniature Limited Historic Wings Montaj Talimatları Kılavuzu - Sayfa 8

Oyuncak Aircraft in Miniature Limited Historic Wings için çevrimiçi göz atın veya pdf Montaj Talimatları Kılavuzu indirin. Aircraft in Miniature Limited Historic Wings 10 sayfaları. 1:72 metal kit of the 1906 santos dumont 14 bis

Sayfayı Yazdır

C Put the left wing assembly in position. Engage the slots in the wing spars with

those in the wing ribs and attach the right wing assembly. Bond the joints and leave

the assembly until the adhesive has cured.

D Make sure it is straight, then cut a length of stainless steel wire to make the

elevator pivot. Put it through the holes in the centre of the rudders and the lugs on

the forward edge of the fuselage structure.

6 LANDING GEAR AND DETAIL PARTS ASSEMBLY (See Figure 9)

A Remove these components from the frets and remove any burrs from the

attachment tags:

Control column

Elevator control centre

Four exhaust manifolds

Fuel tank support

Tailwheel arm

Tailwheel leg

Two elevator control frames.

PROPELLER

A R

R W

F O

BALLAST

TAILWHEEL LEG

B Engine, drive shaft and propeller

(1) Drill 0.75mm/.03" diameter holes in the rear face of the propeller hub and the

aft face of the engine for the ends of the drive shaft.

(2) Attach the four exhaust manifolds to the top of the engine.

(3) Attach the engine to the engine bearers.

(4) Make sure the wire is straight, then cut a length to make the drive shaft. Use the

distance from the installed engine to the end of the fuselage as a guide for the

length.

(5) Attach the drive shaft and propeller.

C Attach the two ballast tanks adjacent in the fuselage.

D Main wheels.

(1) Cut a piece of wire for the main wheel axle, or use a dressmakers pin (not

supplied in this kit).

FOUR EXHAUST

MANIFOLDS

DRIVE SHAFT

TANKS

TAILWHEEL

ASSEMBLY

FUEL TANK

SUPPORT

ENGINE

TAILWHEEL ARM

TAILWHEEL AXLE

Figure 9

CONTROL

COLUMN

ELEVATOR

CONTROL

FRAMES

ELEVATOR

CONTROL

- CENTRE

OIL TANK

MAINWHEEL

AXLE

MAINWHEEL

ASSEMBLY