Dynalite DMC810GL Руководство по установке - Страница 8

Просмотреть онлайн или скачать pdf Руководство по установке для Контроллер Dynalite DMC810GL. Dynalite DMC810GL 12 страниц. Leading edge dimmer/hf ballast controller

Dynalite DMC810GL Руководство по установке

preset programming using the program key

.........................................................................................................................
STEP 1:
STEP 2:
STEP 3:
STEP 4:
STEP 5:
STEP 6:
.........................................................................................................................
Select Preset to be changed by pushing buttons 1-4. The button
LED will indicate current scene.
Hold down the PROGRAM button until all the button LEDs light
up (approximately five seconds). The chosen preset button LED
will be flashing.
To increase or decrease the brightness of all channels at the
same time press the up, down or off button until the required
brightness is required.
To set the level of an individual channel, press 1–4. The button
LED will indicate which channel you have selected. When more
than 4 channels are to be set, press 1 twice for channel 5, press
2 twice to select channel 6,- press 1 three times to get channel 9
etc.
Each press of the button increases the active channel
number by 4.
Press the up, down or off buttons until the lamps on the selected
channel reach the desired level. Select the next channel and
change in the same way.
When all channels of the preset scene have been established,
press PROGRAM again and the levels will be stored to the
current preset. To program another preset, repeat steps 1 - 6.
DMC810GL Instruction Manual Rev B.DOC
8