Dynalite DMC810GL Installationshandbuch - Seite 8

Blättern Sie online oder laden Sie pdf Installationshandbuch für Controller Dynalite DMC810GL herunter. Dynalite DMC810GL 12 Seiten. Leading edge dimmer/hf ballast controller

Seite drucken

1. Useful Dynet Op Codes

preset programming using the program key

.........................................................................................................................

STEP 1:

STEP 2:

STEP 3:

STEP 4:

STEP 5:

STEP 6:

.........................................................................................................................

Select Preset to be changed by pushing buttons 1-4. The button

LED will indicate current scene.

Hold down the PROGRAM button until all the button LEDs light

up (approximately five seconds). The chosen preset button LED

will be flashing.

To increase or decrease the brightness of all channels at the

same time press the up, down or off button until the required

brightness is required.

To set the level of an individual channel, press 1–4. The button

LED will indicate which channel you have selected. When more

than 4 channels are to be set, press 1 twice for channel 5, press

2 twice to select channel 6,- press 1 three times to get channel 9

etc.

Each press of the button increases the active channel

number by 4.

Press the up, down or off buttons until the lamps on the selected

channel reach the desired level. Select the next channel and

change in the same way.

When all channels of the preset scene have been established,

press PROGRAM again and the levels will be stored to the

current preset. To program another preset, repeat steps 1 - 6.

DMC810GL Instruction Manual Rev B.DOC