Hides HV-122 Руководство

Просмотреть онлайн или скачать pdf Руководство для Приемник Hides HV-122. Hides HV-122 4 страницы.

Печатать страницу

HiDes Receiver HV-110/HV-120/HV-122

Here are some set up and usage tips for the HIDes DVB-T receivers for use with

the W0ATN repeater and is provided to supplement each receiver's Quick Start

Guide (QSG) document.

For a new receiver or firmware update, perform the initial Setup in the

following order:

Rear panel Bandwidth (BW) selection switch must be in the Down (2-4) position

before applying DC power.

To quickly switch between 426.000 and 440.000, a microSD card is required to

store these two frequencies in the file "CustomChannelTable.txt."

may be found on the DVD provided with the receiver.

has commercial TV channel frequencies).

change the frequency of the first two channels to 426000 and 440000 with 4MHz

BW using your text editor. The file should be put in the root directory of the

microSD card. While your here, make a new directory in the root and name it

RECORD. This is where any recordings (using the RED button on the OSD

controller) will be stored.

Defined Channel and answer Yes to the process question.

frequencies will be "scanned" with an on-the-air signal and then added in the

Channel Manager.

If a microSD card is not handy (use any size card up to 32MB) or do not want to

do the above, then start with Step 1 and skip over Step 2.

1 -

Main Menu - Settings

Display Preference

Display Mode

PAT Mismatched

Keep Last Video

Warning Message

(use "Factory Defaults" for all others)

2 -

Main Menu - Installation

installed in the receiver first)

Country

Defined List

After selecting User Defined, push the RED button, answer yes and the scan will

begin. Repeat this for the 2nd frequency but answer No (see next Note).

Next, go to the Tools menu and select User

1080P60 or 1080PI60

Disable

OFF

(microSD card edit as described above must be

User Defined

(www.hides.com.tw)

File requires editing (it

Keep the format the same and just

Quick Start Guide, refer to User

This file

Later, these two