Hides HV-122 Руководство - Страница 2
Просмотреть онлайн или скачать pdf Руководство для Приемник Hides HV-122. Hides HV-122 4 страницы.
Печатать страницуNote: A scan must be done for each frequency added in the
CustomChannelTable.tst file.
Manager unless it has been scanned and received with a valid signal (green LED
on).
Frequencies (channels) must be in the Channel Manager to switch between
them using the OSD Remote or buttons on the front of the HV-120/122 receiver.
"Scanning' the frequency receives the transmission data (TSP - frequency, BW,
FEC, GI, etc) sent by the transmitter to the receiver. The receiver needs to
know this data first before video from the transmitting station can be
displayed.
In the Channel Manager, use the OSD remote Blue button to lock each
added channel to its assigned number which will be shown on the front panel
display.
3 -
Main Menu - Installation
CustomChannelTable.txt file)
Country
4MHz Bandwidth and repeater input 440000 4MHz Bandwidth)
Push the Green Button (Refer to Quick Start Guide-OSG Channel Scan Manual Mode
and follow it to add a frequency into the Channel Manager)
Note: The later version OSD remote allows a frequency to be entered without
using the up/down arrows.
strength/quality bars may or may not display the signal even if you know your
station or the repeater signal is valid. If this happens, click on Save and the
scanning process will start anyway. Answer Yes for the first frequency scan and
No for the second frequency scan.
the signal has been scanned will (should) always show the signal strength and
quality if needed to adjust your antenna direction.
antenna direction changes a few degres at a time and wait a few seconds between
movement to allow the signal processing update the signal strength and quality.
Keep one eye on the "green" valid signal LED.
a flicker free and solid green display of light.
the Channel Manager, the OSD remote or front panel pushbuttons may be used to
change channels.
Note on DVB-T signal:
Minimum 15dB signal to noise (SNR - higher number the better) is needed to give
sufficient margin for signal fades and minimum received errors. Signal strength
should be -80dB or lower.
HD with expectations of full motion, a relatively strong signal and high SNR is
required.
The highest SNR for 16QAM is 26dB. Signal strength in the low -60s
dBm or lower will provide SNRs in the -20s.
4 -
Main Menu - Time Manager - there is no real-time clock in this model (-
110/120/122) of receiver so this does not apply.
A frequency will not be added to the Channel
(without using microSD card and
ATV(US)-2/3/4
Just enter digits 426000 or 440000.
Returning to Installation/manual mode after
Because 16QAM is being used in 4MHz BW and 1080p60
(frequencies: repeater output 426000
If using a yagi, make
A good valid signal will provide
Once both frequencies are in
The signal