DC Matic TL-900 Руководство пользователя - Страница 2

Просмотреть онлайн или скачать pdf Руководство пользователя для Ударный драйвер DC Matic TL-900. DC Matic TL-900 5 страниц. 24-30 vdc powered 3/4 inch drive impact wrench system

Печатать страницу

Tool Use And Care



Operate the Model TL-900 in 1 - 2 second long bursts. If the tool does not loosen the fastener

(nut or bolt) after (3) 1 – 2 second bursts STOP and use other means to loosen the fastener.



Use only impact "rated" sockets. Non-impact sockets can break and cause

personal injury or property damage.



Always finger tighten fasteners before securing with the

threading.



Make certain that impact sockets are securely seated over the fastener prior to tightening or

loosening a bolt or nut.



Always use the correct size impact socket size. Incorrect sockets can damage the fastener or

slip off causing injury.



Always clean your

Operating Instructions



Hold the

Model TL-900

gles or other approved eye protection. Heavy impacting can cause flying debris that can cause

permanent eye damage.



Sockets and fasteners can get hot during operation. Use protective gloves when handling them.



Do not operate the

ing action may be harmful to your hands and arms. Use thick gloves to provide extra cushion and

limit exposure by taking frequent rest periods.

Operating Voltage

Your

Model TL-900

(intermittent) to generate optimum impacting strength.

If you have a solid source of 24-30 VDC applied to your

tool seems sluggish or weak, please contact DC-Matic to obtain a return authorization (RMA) so we can

expedite the repair or replacement of your tool or arrange to have a new set of motor brushes sent to

you.

Thermal Protection/Cut Off

Your

Model TL-900

is equipped with an internal, bi-metal thermostat that will shut-down the tool (kill the

trigger switch) when the tool becomes over-heated. Testing has revealed that this tool's thermal

protection circuit will not activate if the

amount of cool-down time between uses.

Note: When used in an ambient temperature of 90 degrees F the average amount of time needed for

the thermal protection circuit to re-set time is (30) minutes.

Control Box

Your

Model TL-900

is equipped with a forward-positioned, 12-cluster LED work light (shown in Fig. 1).

The work light's On/Off switch is located on the control box (shown in Fig. 3). To achieve the highest

degree of workplace safety always turn ON the work light when operating the

no-light environment.

The control box is "Factory Sealed" and must remain that way. Unauthorized

opening of the control box will void the tool's warranty.

Model TL-900

and all electrical connectors after use.

firmly using both hands while operating it. Always wear safety gog-

Model TL-900

for long periods of time. Vibration caused by the tool's impact-

requires a source of 24-30 VDC that is capable of providing 100 AMPS

Model TL-900

and the impacting strength of the

is used intermittently and allowed an adequate

to avoid cross-

Model TL-900

in a low or