Autopage C3-RS-601 Руководство по установке - Страница 13

Просмотреть онлайн или скачать pdf Руководство по установке для Дистанционное пусковое устройство Autopage C3-RS-601. Autopage C3-RS-601 19 страниц. Remote car starter
Также для Autopage C3-RS-601: Краткое руководство по установке (2 страниц)

Печатать страницу

** This will be used when connected to an Autopage CI3 compatible Two-way data module that will recognize

the tach signal from the vehicle. This signal will need to be learned in the same manner as the analog

tachometer wire. If this learned value needs to be adjusted, use steps 7 and 8 of this programming table

RPM LEARNING

1. Turn the Ignition 'switch 'ON/OFF' 3 TIMES and stay in the 'OFF' position.

2. Push the Programming switch 3 times and hold it until the LED turns on and three chirps with a long chirp is heard; then

release the Programming switch. You are now in the feature 'III' programming mode.

3. Press and release the transmitter

confirm this setting.

4. Press and release the transmitter

5. Start the vehicle with the key. (While the engine is running, the parking & LED will flash, If don't, please check

tachometer White/Red wire connection. (H3/1)

6. Press and hold the program switch for 2 seconds until a long chirp and the LED light constant for two seconds. The

RPM signal is learned.

7. Turn the ignition switch off to exit the program mode. 3 long chirps & 3 parking light flashes will confirm exit.

RETURN TO FACTORY DEFAULT SETTING:

1. Turn the ignition 'ON' then 'OFF' 3 TIMES and stay in the 'OFF' position.

2. Push the Programming switch 10 times and hold it on the 10

LED turns on; then release the Programming switch. You are now in the "Return To Factory Default Setting" programming

mode. *Optional horn output must be installed to hear the chirps.

3. Press the

long chirp and 3 parking light flashes to confirm the system "Feature Programming" have all returned to the factory default

settings.

Exit: Turn the ignition switch "on" or leave it for 15 seconds. 3 long chirps & 3 parking light flashes will confirm exit.

TO REMOTE START THE VEHICLE:

1. Press the transmitter

2. The parking light will activate to indicate the remote start received the signal.

3. It will take approximately 5 seconds for the engine to start.

4. Once the engine is running, after couple seconds the parking light will turn on again and climate controls will

activate and adjust the vehicles interior temperature to your preset setting.

5. The vehicle will run for 5 to 30 minute cycle and automatically shut down.

RS-603 REV A.

button once to set the "Tachometer Checking Type". [1] LED flash, [1] chirp to

button once; [1] chirp to indicate your are in features "RPM Learning mode".

buttons on the transmitter together for 6 seconds, there will be a confirmation of six chirps with 3

button twice to start the vehicle.

push. When ten chirps with a long chirp is heard*and the

7/9/2008