Autopage C3-RS-601 Руководство по установке - Страница 14

Просмотреть онлайн или скачать pdf Руководство по установке для Дистанционное пусковое устройство Autopage C3-RS-601. Autopage C3-RS-601 19 страниц. Remote car starter
Также для Autopage C3-RS-601: Краткое руководство по установке (2 страниц)

Печатать страницу

The unit has the ability to report the cause of the last shutdown of the remote start system.

Enter:

Turn the Ignition 'switch to 'ON position.

Press the

button on the transmitter.

The LED will now report the last system shutdown by flashing for one minute in the following grouped patterns:

LED

Shutdown Mode

Flashes

(-) Safety Shutdown input (Hood)

(+) Safety Shutdown input (Brake) or

Neutral Safety Switch input fail.

No RPM or

Low Voltage.

Over-rev

System timed out

Transmitter

Tach. Signal has not been learned

There are 5 reasons why the remote start

1. The Black/White Neutral Safety wire is not grounded. Must be grounded to start.

2. Hood Pin switch White/Black wire has a ground present. Must not show ground to start.

3. Brake pedal switch White/Violet has 12 volt present. Must not show 12 volt to start.

4. The system is in Valet mode.

5. The remote start feature programming has not been programmed to start the vehicle. The remote start must be

programmed how to start the vehicle.

Caution!! The following procedure must be performed after the installation of the Remote Start Device. It is the responsibility

of the installing technician to complete these tests. Failure to test the unit in the following manner may result in personal

injury, property damage, or both.

1. Test the BRAKE shutdown circuit: With the vehicle in park (P), start the vehicl e using the remote transmitter, Once the

engine is running, press the brake pedal. The vehicle should shut down immediately. If the vehicle continues to run, check

the brake circuit WHITE/ VIOLET wire (H3/3) connection.

2. Test the HOOD PIN shutdown circuit: Start the vehicle using the remote transmitter, Once the engine is running, pull the

hood release and raise the hood. The vehicle should shut down immediately. If the vehicle continues to run, check the

hood pin WHITE/ BLACK wire (H3/4) connection.

3. NEUTRAL START SAFETY TEST:

1. Set the vehicle parking brake.

2. Block the drive wheels to prevent vehicle movement.

RS-603 REV A.

SHUTDOWN DIAGNOSTICS

1. Close the hood.

2. Check H3/3 White/ Black wire connection.

3. Check H3/5 White/ Violet wire connection.

4. Move the Enable Toggle Switch to "ON"

position. (If installed.)

5. Move the gear selector to "Park"/ "NEUTRAL"

position.

6. Check H3/4 Black/White wire connec tion.

TACHOMETER CHECKING TYPE:

Check H3/1 White/Red wire connection

VOLTAGE CHECKING TYPE:

Program the "CHECK LEVEL" from

"Hi Check Level" to "Low Check Level"

No transmitter Signal

Re-learning the RPM (Feature

TROUBLE SHOOTING

button will not respond from the transmitter.

TESTING YOUR INSTALLATION:

IV – 2

)

7/9/2008