Dynaudio Contour Руководство пользователя - Страница 8

Просмотреть онлайн или скачать pdf Руководство пользователя для Динамики Dynaudio Contour. Dynaudio Contour 17 страниц.
Также для Dynaudio Contour: Руководство пользователя (20 страниц), Руководство пользователя (20 страниц), Руководство пользователя (17 страниц)

Печатать страницу

Dynaudio Contour

Fig. 1 - Binding posts at rear of cabinet (example).

Connecting

1. Connect a two-pole (+/-) loudspeaker cable to the binding posts, located at rear of

the cabinet (see Fig. 1). The high quality, gold-plated binding posts can accommodate

different connection systems:

4.0 mm banana plugs:

The pins can be put

directly into the binding

post without any tightening

necessary.

Note

• With every connection system, ensure that the contact is tight and has a proper

contact area.

• Connectors with similar gold plating as binding posts will typically offer the best

results and remain corrosion-free.

• Please ensure that the positive and negative cables do not make contact with each

other. Tighten the posts, and check the contact after a few days to make sure that it

hasn't loosened.

Cable spades:

Bare wires:

Loosen the binding posts,

Loosen the binding posts

insert the spade into the

and place the cable into

opening, and secure the

the binding posts. Tighten

spade by tightening the

the posts.

posts.

Fig. 2 - Amplifier loudspeaker outputs (example).

2. Connect the other cable ends to the

Bi-wiring/bi-amping

loudspeaker outputs of your switched-off

Dynaudio loudspeakers feature a

power amp (see Fig. 2).

carefully fine-tuned cross-over, optimised

using selected parts and an advanced

Note

circuitry to achieve a truly balanced and

Please make sure that the red marked

smooth frequency response. Therefore,

post of the speaker is connected to the

dividing the frequency sections through

red marked output of the amp, and the

bi-wiring or bi-amping is neither

white or black marked post to the white

beneficial nor optional.

or black marked output accordingly.

Choice of loudspeaker cable

The loudspeaker cable can have an

impact on sound quality. In general,

quality cable products will yield a quality

result.

Dynaudio loudspeakers are designed

to be very neutral and thus are not

extremely suited to any particular type

of cable. The choice of cable is as much

a factor of matching the cable to the

Speakers

entire audio system. Please consult your

Dynaudio dealer for information about

compatible loudspeaker cables that

will suit both your electronics and your

Dynaudio loudspeakers.

Connecting surround speakers

When connecting a two-channel stereo

system, only the right and left channels

are connected to the amplifier.

In a surround set-up, centre, side or rear

loudspeakers as well as a subwoofer are

typically connected to provide for a

multi-channel listening experience.

Please refer to the amplifier's owner's

manual for particular connection

scenarios and see section "Multi-

channel set-up" on page 23 for further

instructions.

Connecting