hikam S5 Руководство по первоначальному запуску - Страница 4
Просмотреть онлайн или скачать pdf Руководство по первоначальному запуску для Камера безопасности hikam S5. hikam S5 6 страниц. Smart home wireless ip-camera
Печатать страницу
Option 2: Launch using „Smart Scan"
If using „AirLink" there is no sound ("Dong..."), try using "SmartScan":
- Follow Preparation Steps 1, 2 and 3.
(see above)
- Configure camera using "SmartScan". The app will guide you through the configuration step by step
(see
.
pictures 7 through 12)
- Put camera on a surface and put smartphone within 20 to 30cm in front of the camera. If you don't hear a
sound ("boing") within 5 seconds, slightly adjust the angle or position of the smartphone and try again.
(see
picture 11)
Picture 7
Picture 8
Picture 9
Picture 10
Picture 11
Picture 12
- Once the camera has identified the configurations from the OR code, you will hear a signal („Dong ...").
After that please click "Heard" on the App. The camera will connect to the router. Once connected, a
permanent blue LED light will turn on.
- You are asked to name the camera and to enter the initial camera password which is 123.
(see picture 5)
- You will then be asked to enter a new password, consisting of 6-9 digits. Please do NOT start with "0"
(see picture 6)
- You can now follow the live video stream on your smartphone (blue LED light will flash during live video
mode)
Installation Manual
- Hold mounting plate with one hand and screw on white frame counter-clockwise to open / clockwise to
close
(see pictures 13 and 14).
- For vertical installation, set mark pointing up
(see picture 15).
- The RESET button is located on the back of the camera
(see picture 15).
Picture 13
Picture 14
Picture 15
Support:
http://support.hi-kam.com
For further instructions, video tutorials, software, data sheets, specs, FAQs.
Guaranteed feedback within 24hrs, often within 4hrs.