AGS Merlin Инструкции по установке и эксплуатации - Страница 13

Просмотреть онлайн или скачать pdf Инструкции по установке и эксплуатации для Детекторы газа AGS Merlin. AGS Merlin 16 страниц. Refrigerant gas detector tft
Также для AGS Merlin: Руководство по эксплуатации и установке (5 страниц), Руководство по эксплуатации и установке (6 страниц), Руководство по установке и эксплуатации (12 страниц)

Typical Sensor Life Expectancy

The End-of-Life message is approximate from the first five (5) hours of continuous power!

The End of Life will depend on the type of gas your detector is targeting and may vary depending on its application

and environmental conditions such as the frequency of exposure to the target gas, poisons, or inhibitors!

The typical life of a gas detector depends on its application and intended target gas, in addition the

operational life can be prolonged if the system and equipment is installed and maintained in accordance the

instructions stated within this manual.

At the end of its predicted operational life – the detector will display an 'End of Life' screen. This message

indicates that the detector has reached its expected operational lifecycle and no gas levels are displayed.

You must contact your supplier immediately for replacement.

Sensor Type

NDIR – Non dispersing Infrared

** Normal Use. The typical life of a sensor depends on its application and intended target gas, in addition the operational

life can be prolonged if the system and equipment is installed and maintained in accordance with these instructions.

Disposing of Electrical & Electronic Equipment (WEEE)

When this product has reached the end of its life it must be treated as Waste Electrical & Electronics

Equipment (WEEE). Any WEEE marked products must not be mixed with general household waste, but kept

separate for the treatment, recovery and recycling of the materials used.

Please contact your supplier or local authority for details of recycling schemes in your area.

For more help and advice on bump testing – contact us.

Always give at least five (5) minutes between testing the same unit or until gas has fully dispersed!

A bump test is a live test of the system to verify that the detector responds to gas and all connected alarm

devices, BMS, etc. are operating accordingly. It is recommended that all involved persons are informed about

the test and certain alarms might have to be inhibited (e.g., shutdown valves, notification of authorities, etc.).

If the system fails to operate as intended in an alarm state, the gas detector must not be used until a full

inspection and service has been conducted. A detector may visually appear in good working order, but its

sensitivity and accuracy can be inhibited by external factors. Dust, humidity, temperature fluctuations,

cleaning products, contaminants, exposure to its target gas or sensor drift (ageing) can cause a decline in

sensitivity, accuracy, and eventual failure.

Rev 01

Merlin Gas Detector Installation & Operation Instructions

Long Term Stability

+3% FS per annum

Lifetime**

>5 Years

Page 13 of 16