aireRyder eFan FN4113 Series Инструкция по установке и использованию - Страница 3

Просмотреть онлайн или скачать pdf Инструкция по установке и использованию для Вентилятор aireRyder eFan FN4113 Series. aireRyder eFan FN4113 Series 11 страниц.

Печатать страницу

Risk of electric shock: The electrical installation must be performed by a qualified electrician and

must be in accordance with national and local regulations.

Risk of injury: In case you need to drill holes for mounting the fan, make sure that the drills have

sufficient distance to in-ceiling wiring.

1. Pass the supply wires through

the hole in the mounting bracket.

Secure the mounting bracket to a

ceiling joist or other structural

ceiling element with two screws and

flat washers. Ensure that the

support for the mounting bracket is

capable of safely holding the

moving weight of the fan.

4. Hang the fan assembly with the

ball joint onto the mounting bracket.

Make sure the guide pin of the

bracket is fitted into the

corresponding slot of the ball joint.

You should feel the guide pin

setting into the slot of the ball joint.

Note: For slope ceiling installation,

make sure the guide pin of the

hanger bracket is toward the floor.

7. Attach nipple to the coupling,

and secure it with a hex nut. Install

suitable bulbs (E14 socket, 60W

max.; not included).

2. Remove the lock pin and take

off the hanger pin.

Slide canopy

and downrod stand cover onto

downrod as shown. Then thread

wires from fan assembly through

downrod.

5. Terminal block wire connections:

First, loosen the screws on the

terminal block, then make sure that

all exposed wires are inside the

terminal block and screws are

securely tightened again. Then,

make wire connections of supply

wires with corresponding wires

from fan using the other side of the

terminal block.

Note – wiring from fan:



brown (L)



blue (N)



green/yellow (ground)

Insert the downrod into the

collar. Slide hanger pin through

holes of collar and downrod.

Insert and tighten the two collar

screws. Slide lock pin into

hanger pin until it locks into

position.

6. Tuck all wires into the

canopy. Push the canopy

upwards, lining up the

keyholes on the bottom with

the screws on the hanger

bracket. Twist the canopy

to lock it in place, then tighten

the screws to secure it.

8. Attach the glass shade

and metal pad through the

nipple, secure them

together with a hex nut and

finial.