aireRyder eFan FN4113 Series Инструкция по установке и использованию - Страница 4
Просмотреть онлайн или скачать pdf Инструкция по установке и использованию для Вентилятор aireRyder eFan FN4113 Series. aireRyder eFan FN4113 Series 11 страниц.
Печатать страницуOPERATING THE FAN
Check the fan before switching it on!
Risk of injury: The fan can only be operated if no defects have been found upon inspection.
In case a part is defective, it will have to be replaced before using the fan.
Check that the fan is in safe operating condition:
Check to make sure that there are no visible defects.
-
Verify that all parts are properly installed and fastened.
-
Remote Control
Step 1: Set the frequency
The frequency setter is located under the
battery cover.
Initially, all 4 keys are set in upward position. If
more than one remote-controlled fan is installed
or if frequency interference occurs, the fan may
function abnormally. In this situation, reset the
fan frequency as follows:
1. Remove battery cover.
2. Use a pen (or any convenient tool) to switch
keys to select a frequency mode which will not
interfere with other electronic devices. There
are 15 frequency modes available excluding
the original ex-factory mode (see illustration).
Note: Set different remote-controlled fans in
one building at different frequency modes.
Step 2: Program the fan
1. Install two AAA batteries (not included) into
the transmitter.
2. Turn on the power to the fan.
3. Within 30 seconds after power is turned on,
press and hold the "OFF" button for 5 seconds.
Once the code has been set successfully, the
fan will make a "beep" sound.
Step 3: Operate the transmitter
* Press "HI" to turn on the fan to high speed.
* Press "MED" to turn the fan to medium speed.
* Press "LOW" to turn the fan to low speed.
* Press "OFF" button to turn off the fan.
* Press and release the
to turn on or turn off the light.
* Press and hold the
brighten lights to the desired level.
Important: Energy saving (CFL) light bulbs are not recommended for this item.
Note: This remote control has a memory function for the fan light.
If the fan light is switched off using the remote control, it will return to the same level of
brightness when switched on again.
If the power is switched off using the main power switch, the light will turn back on to full
brightness when the main power is switched on again.
button quickly
button to dim or
1 key in upward position:
2 keys in upward position:
3 keys in upward position:
4 keys in upward or downward position:
4