Dean 2424E Руководство по установке, эксплуатации и техническому обслуживанию - Страница 7

Просмотреть онлайн или скачать pdf Руководство по установке, эксплуатации и техническому обслуживанию для Фритюрница Dean 2424E. Dean 2424E 15 страниц. Flatbottom series electric fryers (ce)

Печатать страницу

2. Adjust leg height with an adjustable

or 18 mm open-end wrench.

3. When leveling the fryer, hold the leg

body firmly to keep the leg from

rotating while turning the hex bullet

foot.

c. All Installations: If the floor is uneven

has

recommended to place the fryer on a

smooth platform.

leg/caster thread adjustment.

d. Re-leveling: If the fryer is moved, re-

level the fryer following the instructions

given in Step 3.4.

e. Restraints: This fryer must be restrained

to prevent tipping when installed in

order to avoid the splashing of hot liquid

and prevent undue strain on the

electrical connectors.

restraint may depend on the type of

application, such as connecting to a

battery of appliances or installing the

fryer in an alcove, or by separate means

such as restraining devices. A bracket

has been provided on the fryer back

panel for this purpose.

The installation must be reviewed at

the time of installation to ensure it

meets the intent of these instructions.

The

on-site

operator(s) should be made aware

there is a restraint on the appliance

and, if disconnection of the restraint is

necessary, to reconnect this restraint

after the appliance has been returned

to its originally installed position.

3.5 ELECTRICAL CONNECTIONS:

Refer to the rating plate located inside the front

door. The wiring diagram is attached to the

inside of the fryer door also. The diagram can

also be found in Chapter 8.

equipped with a 230VAC single-phase 50 hertz

system.

All electrically operated appliances

must be electrically grounded to conform to CE

standards. If a power cord is installed on your

unit, do not cut or remove the ground prong

decided

slope,

Do not rely on

The means of

supervisor

and/or

The fryer is

from that power cord plug. Respect the phase –

neutral polarity. Do not attempt to use the

fryer during a power outage.

When the fry vessel is filled with water, do

not drain the water from the vessel into the

filter. This will damage the filter pump and

void the warranty.

3.6 INITIAL START-UP:

a. Cleaning: New units are wiped clean

with solvents at the factory to remove

any visible signs of dirt, oil, grease, etc.

remaining from the manufacturing

process, then coated lightly with oil.

Wash thoroughly with hot, soapy water

to remove any film residue and dust or

debris before food preparation, then

rinse out and wipe dry. Wash also any

accessories shipped with the unit. Close

the drain-valve completely. Make sure

the screws holding the thermostat and

high-limit control sensing bulbs into the

vessel are tight.

b. Initial Checks:

fryers

calibrated before leaving the factory.

Adjustments to assure proper operation

may be necessary on installation to

correct possible problems caused by

rough handling or vibration during

shipment, and are to be performed only

by qualified service personnel. These

are the responsibilities of the customer

and/or dealer and are not covered by

Dean Industries' warranty.

c. Ensure that the following steps are

done in sequence before using the fryer:

1. Turn the temperature control knob

to "OFF".

2. Fill fryer tank with liquid oil (or

water during initial testing) to the

"oil level" line scribed into the rear

wall of the tank.

CAUTION

All Dean Industries'

are

tested,

adjusted

and