HIKOKI CB12-ST2 Инструкции по передаче - Страница 7

Просмотреть онлайн или скачать pdf Инструкции по передаче для Пила HIKOKI CB12-ST2. HIKOKI CB12-ST2 16 страниц. Band saw stand

Pulley guard (B)

Slide cover

Butterfly bolt

(5 mm)

M8 bolt

Slide cover holder

(1) Turn the lever switch on.

(2) Hold the workpiece with both hands. Slowly slide it on the

contour table to the band saw blade to cut its contours.

(3) Press the workpiece against the band saw blade by

exerting a load that is not excessive to the point where

it warps the blade. Exercise care not to apply excessive

loads to the blade.

NOTE

Turn the lever switch oﬀ each time you ﬁ nish cutting

workpieces.

Lever switch

OFF

Workpiece

Contour table

Protrusion

Fig. 16

Band saw blade

Fig. 17

10. Moving the band saw installed on the band saw

stand

When moving the band saw installed on the band saw

stand, move the main unit down to the lower limit position

as shown in the ﬁ gure below. Tighten the stopper bolt so

that the main unit does not move up, then hold both ends

of the base. (Fig. 18-a)

The band saw stand has wheels, which enables you to

hold the front handle and lift the pulley guard (B) side to

move the band saw. (Fig. 18-b)

NOTE

Remove the band saw blade and battery even when you

move or store the band saw installed on the band saw

stand.

Stopper bolt

English

Stopper bolt

Fig. 18-a

Front handle

Wheel

Fig. 18-b