HIKOKI CB12-ST2 Инструкции по передаче - Страница 5

Просмотреть онлайн или скачать pdf Инструкции по передаче для Пила HIKOKI CB12-ST2. HIKOKI CB12-ST2 16 страниц. Band saw stand

Печатать страницу

<Adjustment of the perpendicularity between the top surface

of the base and the band saw blade>

(1) Apply the vise guide to vise (B), and lightly secure the

vise guide using vise (A). (Fig. 9)

Vise (A)

(2) Loosen the two band saw adjustment bolts using

the 8-mm hexagonal wrench supplied as a standard

accessory.

Hold the front handle and move the main unit up and

down to adjust its angle so that a uniform amount of

clearance is created between the side of the vise guide

and the band saw blade. (Fig. 10)

(3) Tighten the two band saw adjustment bolts to ﬁ rmly

secure hinge (B).

NOTE

If a higher level of cutting precision is required, adjust the

vise position using a speed square.

Hinge (B)

Band saw

blade

Top surface

of the base

Side of the

vise guide

5. Setting the cutting load

In order to set the cutting load, lift and hold the main unit

at the upper limit position, then change the position of the

spring stopper. (Fig. 11)

When cutting thin wall steel pipes (with a wall thickness

of 2 mm or less), PVC, or plastic materials, set the cutting

load to "Light load" or "Lightest load".

NOTE

● When setting the cutting load, be sure to lift the main unit

to the upper limit position.

Vise guide

Vise (B)

Fig. 9

Band saw

adjustment bolts

Hinge (A)

Band

saw blade

Fig. 10

If the spring stopper is pressed in when the main unit is

in a low position, the force of the spring will be applied

in the opposite direction, preventing the main unit from

being able to be lifted to the upper limit position.

● Setting a lighter cutting load increases the length of time

required to cut workpieces, however, cutting precision

will be improved.

Pull out the spring stopper.

(Remove it from surface

Insert it into hole

Hole

Spring stopper

6. Securing workpieces

Vise (A) of the band saw stand can be moved faster

when the clutch is released, and can be used to press

a workpiece when the clutch is applied. You can carry

out your work eﬃ ciently by appropriately moving the vise

faster and pressing it against workpieces.

(1) Place a workpiece on the top surface of the base, and

press it against vise (B).

(2) Release the clutch, and move vise (A) until it comes in

contact with the workpiece.

(3) Apply the clutch, and turn the knob clockwise to secure

the workpiece. (Fig. 12)

Workpiece

Clutch

Release

Tighten

Knob

NOTE

If the clutch cannot be released, turn the knob

counterclockwise a little.

English

"Heavy load"

"Medium load"

"Light load"

"Lightest load"

Hole

Lighter

Hole

Heavier

Surface

Fig. 11

Vise (A)

Vise (B)

Apply

Fig. 12