Adexa UC200-2036D Руководство по установке / Руководство по эксплуатации и уходу - Страница 11

Просмотреть онлайн или скачать pdf Руководство по установке / Руководство по эксплуатации и уходу для Вентиляционная вытяжка Adexa UC200-2036D. Adexa UC200-2036D 20 страниц. Under-mount hood

Печатать страницу

ELECTRICAL REQUIREMENTS AND

INSTALLATION WARNING

THIS RANGE HOOD MUST BE PROPERLY GROUNDED. TURN OFF ELECTRICAL POWER AT SERVICE ENTRANCE

BEFORE WIRING. CHECK TO MAKE SURE THAT THE ELECTRIC CORD IS NOT IN CONTACT WITH THE SHARP

EDGES OF THE APPLIANCE.

IMPROPER GROUNDING CAN RESULT IN A RISK OF ELECTRIC SHOCK. CONSULT A QUALIFIED ELECTRICIAN IF

THE GROUNDING INSTRUCTIONS ARE NOT COMPLETELY UNDERSTOOD OR IF THERE IS DOUBT AS TO

WHETHER THE APPLIANCE IS PROPERLY GROUNDED. DO NOT USE AN EXTENSION CORD. IF THE POWER

SUPPLY CORD IS TOO SHORT, HAVE A QUALIFIED ELECTRICIAN INSTALL AN OUTLET NEAR THE APPLIANCE.

• This appliance must be plugged into an outlet that is properly installed and grounded. In the event of

an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire

for the electric current.

• Position the outlet offset so that the power cord will not interfere with the round duct. Make sure

this does not interfere with the mounting bracket.

ADVANCED PREPARATION

WARNING

Three or more persons are required to move and

install this range hood. Spinal or other bodily injuries

could occur if these instructions are not followed.

• Decide on the location of the venting pipe from the hood to the outside.

• A straight, short vent run will allow the hood to perform more efficiently. Try to avoid as many

transitions, elbows and long runs as possible. This may reduce the hood's performance

• Use duct tape to seal joints between pipe sections.

• For installing under the cabinet with recessed bottom, attach 4'' wide wood filler strips (not

provided) on each side. See Figure 1.

• Using references in measurements and installation diagrams (see page 7), create access

opening for electrical wires and hood exhaust under thecabinet.

CAUTION: If moving the cooking range to install the hood, turn OFF the power at the main electrical box.

SHUT OFF THE GAS BEFORE MOVING A GAS RANGE.

• Puncture the knockout holes (for mounting under the cabinet) on the hood as shown in Figure 2.

• If necessary, attach two rubber stands with adhesive tapes to the back corners of the hood.

Figure

WARNING

Risk of severe injury

Rotating fan can cause severe injury.

Stay clear of fan when motor is running

Figure