Adexa UC200-2036D Руководство по установке / Руководство по эксплуатации и уходу - Страница 12

Просмотреть онлайн или скачать pdf Руководство по установке / Руководство по эксплуатации и уходу для Вентиляционная вытяжка Adexa UC200-2036D. Adexa UC200-2036D 20 страниц. Under-mount hood

Печатать страницу
INSTALLATION
Measure the distance between the cooking
surface and the bottom of the range hood. A
distance of 24" to 30" is recommended*.
*
Due to different ceiling height configurations, the
recommended height may not be applicable
Step 1: You have two options for installing this range hood (see INSTALLATION DIAGRAMS on page 7):
A. Determine the venting method and proceed if you would like tovent VERTICALLY.
1. Using references in the Height & Clearance diagram, determine and clearly mark the centerline
on the bottom of the cabinet.
2. Draw electrical wires through cabinet access opening on top of the range hood (refer to figure 3),
center the hood beneath the cabinet and flush with the front of the cabinet.
3. From inside the hood, place hood mounting screws in the exact center of each knockout holes and
secure to the cabinet bottom. Tighten all screws until secure. Be careful when using electrical
screwdriver in order not to damage the range hood. Connect and secure the metal duct (refer to
figure 4). Skip Part B below and proceed to Step 2..
3
Figure
B. Determine the venting method and proceed if you would like tovent HORIZONTALLY.
1.
Using references in the Height & Clearance diagram, determine and clearly mark a centerline
on the wall.
2-1. Draw electrical wires through cabinet access opening on top of the range hood (refer to figure 3),
center the hood beneath the cabinet and flush with the front of the cabinet.
3-1. From inside the hood, place hood mounting screws in the exact center of each knockout holes and
secure to the cabinet bottom. Tighten all screws until secure. Be careful when using electrical
screwdriver in order not to damage the range hood. Connect and secure the metal duct (refer to
figure 5).
5
Figure
.
CAUTION: Make certain the range hood is secure before releasing!
4
Figure
Use aluminum foil tape to
make all joints secure and
air tight.
12