KitchenAid KGCV465MSS03 Руководство по установке - Страница 7

Просмотреть онлайн или скачать pdf Руководство по установке для Варочная панель KitchenAid KGCV465MSS03. KitchenAid KGCV465MSS03 20 страниц. 36" pro line series commercial style cooktop

Печатать страницу

E Remove the top wood sheet from

over the top of the cooktop.

use with Natural and L.R gas. Do not use

teflon tape. You will need to determine the

fittings required depending on your

installation.

m Connect flexible, stainless steel

gas supply connector to the rigid gas

supply line. Do not kink the connector. You

will need to determine fittings required

depending on your installation.

m Remove the shipping brackets and

discard.

Excessive

Weight Hazard

Use two or more people to move

and instatl cooktop.

Failure to do so can result in back

or other injury.

m Carefully lift the cooktop up and set

aside. Write down the model and serial

numbers before installing the cooktop.

Both numbers are on the model/serial

number plate located on left front

underside of the burner box.

E Unpack the burner grates,

Instawok, burner caps, regulator and

island trim. Items are either packaged

under the cooktop or on the cooktop.

mThe pressure regulator and flexible,

stainless steel gas supply line connector

can be assembled to the cooktop now or

after the cooktop is installed in the cutout.

To assemble now, stand the cooktop on

its side or back surface and complete this

part of the pressure regulator/gas line

connector assembly.

To connect the flexible, stainless steel

connector to the pressure regulator

requires a 1/2" nipple.

Install the pressure regulator with the

arrow pointing up toward the bottom of

the burner box and in a position where

you can reach the regulator cap.

IMPORTANT: All connections must be

wrench-tightened. Do not make

connections to the gas regulator too tight.

Making the connection too tight may

crack the regulator and cause a gas leak.

Do not allow the regulator to turn on the

pipe when tightening fittings.

E Attach the backguard or island trim

as required for your installation. Attachment

screws are in the literature package.

E Carefully lift and place the cooktop

into the front area of the cutout. Be

careful not to pinch the power supply cord

or damage the pressure regulator/flexible

gas supply line connector if installed. DO

NOT place all the way back into cutout.

E Place cooktop completely into

cutout. Note: The cooktop must be level

for best cooking performance.

If the pressure regulator and

flexiMe, stainless steel gas supply were

not assembled

in Step 5, complete the

assembly now, The pressure regulator

MUST be installed with arrow on the

regulator pointing up toward the burner

box.

m Open shutoff valve in the gas

supply line. Wait a few minutes for gas to

move through the gas line.

E Leak testing of the appliance

shall be conducted according to the

following instructions:

Test all connections by brushing on an

approved non-corrosive leak-detection

solution. Bubbles will show a leak. Correct

any leak found.

TripmeTier

Hame buraercaps

E Put burner caps on each burner

base. Place burner grates over burner

bases and caps.

Go to "Check the operation of the surface

burners" on Page 8.

Use only pipe-joint compound made for