GAP Quick-Tilt Визуальная инструкция по быстрому монтажу - Страница 3

Просмотреть онлайн или скачать pdf Визуальная инструкция по быстрому монтажу для Антенна GAP Quick-Tilt. GAP Quick-Tilt 4 страницы.

Setting The Quick-Tilt In Concrete

Dig a hole at least 10" in diameter x 24".deep. Set the Quick-Tilt

mount with the attached 5" PVC separators in the hole. Mix up two 80

lb bags of concrete according to the directions on the bag and pour it

into the hole. Using a level, set the Quick-Tilt mount so it is plumb.

Reassembling your Quick-Tilt With The Supplied PVC Pipe

Remove the 5" PVC separators from the 3/8" bolts. If you plan on

using the supplied 11/4" PVC insulator then position it and the two

keepers in between the two support brackets. One of the keepers is

missing a thumbscrew. This keeper should be positioned towards the

top of your support bracket and will eventually accommodate the

stabilizer bolt. Working with the holes on the support bracket closest to

the ground, slide the bolt through the support bracket. Slip one of the

1½" spacers over the bolt before passing the bolt through the hole in

the keeper. As the bolt passes through the keeper slide another 1½"

spacer over it and then continue to push the bolt through until it passes

through the other bracket. Secure it with a wing nut. This bolt is your

pivot bolt.

The bolt on your upper keeper is used to lock your mast, antenna or

flagpole in the vertical position and shall be engaged once you have

walked your structure up. This bolt does not require any spacers.

Once you have walked your structure up, slide this 3/8" bolt through the

support bracket, keeper, and other support bracket and secure it with

another of the large wing nuts.

After locking your structure in place, you can now go ahead and insert the ¼ " stainless bolt. Push this bolt

through the support bracket and slide another 1½" spacer over the bolt as you continue to push this bolt

through the small holes in the keeper. As the bolt passes through the keeper slide the remaining 1½"

spacer over it and continue to push it through until it comes out of the other support bracket. Secure it with

the wing nut. This bolt is your stabilizer and will limit your lateral motion.

If you will not be using the supplied PVC pipe, remove it from the keepers. Place the keepers on your mast

section. The easiest way to achieve this is to simply back off the thumbscrews and wing nuts to the point

that you can slide the PVC section out, without totally removing the wing nuts from the screws. Before

removing the keepers from the PVC pipe you may wish to note their distance between themselves. This will

show you how much separation is required so that all your holes and bolts will line up. With the

thumbscrews backed off slide the two keepers over your support mast . Make sure to put the one keeper

with the missing thumbscrew on first with the vacant hole towards the top. Follow the same steps outlined

above, selecting the appropriate spacer for the desired mast section to be supported. The measurements

provided on the assembled drawing for the spacers correspond to the outer diameter of the mast you will be

using.