CORNING LSE 6781-4 Руководство по эксплуатации - Страница 7
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Лабораторное оборудование CORNING LSE 6781-4. CORNING LSE 6781-4 10 страниц. Digital microplate and orbital shakers
Печатать страницу
Power
RPM signal light is on. By rotating the encoder knob right (+) or left (-) the desired RPM can be selected:
34 = 340 rpm
•
120 = 1,200 rpm
•
Press the START/STOP button to start operation.
Power
RUN and TIME signal lights are on. The shaker runs and counts down the time from the set value.
NOTE: You cannot modify the set time during shaking. However, you can stop the unit with the START/STOP button and then reset the time.
Power
If you want to change the RPM during shaking, push the encoder knob to put the shaker into RPM set mode (RPM signal light will be
on). Rotate the encoder knob right (+) or left (-) to set the desired value. In the meantime RPM signal light will flash. When you stop
rotating the encoder knob, the signal light for RPM will stop flashing after 2 seconds.
Power
When the run time has elapsed or when you press the START/STOP button, End will show on the display and the RUN light will
flash. When the shaker completely stops the set speed and time will return to the last programmed values.
Run
Time
Speed
ENCODER
Speed(RPM) Time(min)
PUSH
(Time/Speed)
Run
Time
Speed
ENCODER
Speed(RPM) Time(min)
PUSH
(Time/Speed)
Run
Time
Speed
ENCODER
Speed(RPM) Time(min)
PUSH
(Time/Speed)
Run
Time
Speed
ENCODER
Speed(RPM) Time(min)
PUSH
(Time/Speed)
Start
Stop
Start
Stop
Start
Stop
Start
Stop
Instruction Manual
|
5